Operating Instructions

RQTC0178
5
Preparations
 Attaching the battery
(When the unit is off)
The illustrations shown are of DY-DB20; however the steps for the other
batteries (→ 4) are the same.
When not using for long periods of time
● Remove the battery pack (→ above).
(Even when the unit is turned off, there is a small amount of voltage running through the unit, and this may result in a
malfunction.)
● Recharge the battery for re-use.
RELEASE
DETAC
H
ATTACH
RELEASE
DETACH
ATTACH
RELEASE
DETACH
ATTACH
Bottom side of this unit
Battery pack
Clicks into place
Check to make sure it is securely fastened.
 Press and hold

g Detaching
● Turn the unit off before
detaching the battery pack.
DC IN
[
^
] goes out → lights*
[CHG] lights → goes out
* Only when recharged with the unit
off.
[
^
] indicator
When the unit is connected to the AC
mains supply, this indicator lights up
in standby mode and goes out when
the unit is turned on.
Started
To household
mains socket
Finished
AC adaptor (included)
 Recharging the battery
The battery is not charged at the time of purchase. Charge before initial use.
The unit is in the standby condition (the
[
^
] indicator lights) when the AC mains
lead is connected. The primary circuit is
always “live” as long as the AC adaptor
is connected to an electrical outlet.
To conserve power
This unit consumes 0.5 W of power
even when turned off. When the unit
is not going to be used for a long time,
disconnect the AC mains lead from the
household mains socket.
● You can also use this unit without charging
while connecting the AC adaptor and the AC
mains lead.
● You can also use this unit without charging
while connecting Car DC Adaptor. (→ 15,
Connecting the included Car DC Adaptor)
Getting started
CHG
AC mains lead
(included)
Recharging time:
→ 6, Approximate recharging and
play times (Hours)
When finished, disconnect the AC
adaptor and the AC mains lead.
RQTC0178-B.indd 5 1/26/2011 14:30:54