Instruction Manual (EB) EN

GENERAL PROBLEMS

Before requesting service

The player does not respond to function key commands:

Certain control operations are not available with some discs.

There may be interference caused by lightning or static charge.

Press [ ] to put the player into stand-by mode.

Restart the player.

The remote control unit does not work:

Playback does not start after pressing PLAY:

Unable to change the audio track or the subtitle language:

The subtitles are not shown:

The audio track or subtitles do not use the language

selected from the menu:

Unable to change the aspect angle:

You forgot your password:

Stop the player and keep pressing player button together with

and also OPEN/CLOSE until [Initialised] disappears from the

screen. This restores all factory defaults. When you are done switch

off the unit and back on afterwards.

Afterwards, display the QUICK SETUP menu to re-initialise

the appliance to your preferences.

OPEN/CLOSE

It depends on the disc whether this function is available.

The disc does not provide the language you selected.

Verify that the batteries are in the right way round (+ and -).

Point the RC unit at the front of the appliance.

Condensation has accumulated inside the player. Wait for 1 to 2 hours.

The player only supports DVDs with regional code 2, ALL or from a

group of regional codes containing regional code 2.

The disc is dirty or damaged.

The disc is in the wrong way round.

The label of the disc you wish to play must face up.

You can only choose from the languages actually

recorded on the disc.

Some discs require you to change the setting

via the Disc menu.

The disc does not provide any subtitles.

You deactivated the display of subtitles.

The subtitles are at the wrong position.

Move the position of subtitles.