Operating Instructions AC/Rechargeable hair clipper for professional use Model No. ER1510 English 2 Português 00 Magyar 00 Deutsch 0 Norsk 00 Română 00 00 Français 00 Svenska 00 Русский Italiano 00 Suomi 00 Türkçe 000 Nederlands 00 Polski 00 Українська 000 Español 00 Česky 00 Dansk 00 Slovensky 00 Before operating this unit, please read these instructions completely. ER1510_EU.
Important Before use This clipper is designed for professional use to trim hair and beards. Charge it for 8 hours before use for the fist time in order to activate the built‑in rechargeable batteries. It can be operated on either an AC adaptor or rechargeable batteries. Read all instructions carefully before use. Charging the clipper • Use the ER1510 hair clipper with the RE5‑95 adaptor only. • Avoid charging the batteries at temperatures below 5 °C or above 35 °C.
Ch ar ge Parts identification 6mm 0/0" 9mm 0/0" the power 1 Connect cord to the charging 3mm 0/0" 12mm 0/0" 4mm 0/0" A Main body 1 Trimming height indicator 2 Dial (Height adjustment control) 3 0·CHARGE/1 switch 4 Battery capacity lamp 5 Charge status ( ) lamp 6 Plug receptance B Blade 7 Mounting hook 8 Cleaning lever 9 Moving blade Stationary blade Charging the hair clipper 15mm 0/0" C 3 mm comb attachment D 4 mm comb attach
2. Plug in the adaptor into a household outlet. About the LED display While charging After charging is completed 10 minutes after charging is completed HIGH MID LOW HIGH MID LOW HIGH MID LOW blinks once every second. blinks once every 2 seconds. • “HIGH/MID/LOW” go out. While using HIGH MID LOW “HIGH” blinks - The battery capacity is enough. “MID” blinks - The battery capacity is approx. 60% or less. “LOW” blinks - The battery capacity is approx. 10% or less. Cu t glows.
Removing the attachment from the clipper Remove the attachment as illustrated. Mounting the blade 1. Set the dial to “2.0”. re 2.0 Ca Blade maintenance Blade life Blade life will vary according to the frequency and length of use. It is expected to be about 3 months when used for 15 haircuts a day. 2. Fit the mounting hook into the blade mounting on the clipper and push in until it clicks. Cleaning the blade Removing and mounting the blade Removing the blade 1.
Lubrication 1. Apply a few drops of the oil to the space between the stationary blade and moving blade. • Apply the oil to the clipper before and after each use. 2. Set the dial to “2.0” and then remount the blade on the clipper. Removing the built‑in rechargeable batteries 1. Remove the blades 1 and four screws 2. 2. Remove the spring 3, the under cover 4, and the blade holder 5. 3. Remove the dial 6 and open the housing 7, and then take out two batteries 8.
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households) WARNING - Do not attempt to replace the batteries for the purpose of reusing the clipper. This could result in the risk of fire or electric shock. Important notice regarding environmental protection The built‑in rechargeable Nickel‑Metal Hydride batteries contain substances that may be environmentally harmful. Please remove the batteries before discarding your clipper.
Matsushita Electric Works, Ltd. 1048, Kadoma, Osaka 571-8686, Japan No.1 EN, GE, FR, IT, DU, SP, DA, PT, NW, SW, FI, PL, CZ, SK, HU, RO, RU, TK, UA (欧州) ER1510_EU.