Operating Instructions AC/Rechargeable Professional Hair Clipper Model No. ER‑GP81 Contents Safety precautions..................4 Care.................................................10 Intended use.....................................7 Troubleshooting.............................12 Parts identification...........................7 Frequently asked questions..........12 Charging the clipper.........................8 Removing the built-in rechargeable battery...........................................
Warning • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. • The supply cord cannot be replaced.
• The following symbol indicates that a specific detachable power supply unit is required for connecting the electrical appliance to the supply mains. The type reference of power supply unit is marked near the symbol. 3 ER-GP81_UK.
Safety precautions To reduce the risk of injury, loss of life, electric shock, fire, and damage to property, always observe the following safety precautions. Explanation of symbols The following symbols are used to classify and describe the level of hazard, injury, and property damage caused when the denotation is disregarded and improper use is performed. DANGER Denotes a potential hazard that will result in serious injury or death.
WARNING Regularly clean the power plug, the appliance plug and the charging plug to prevent dust from accumulating. - Failure to do so may cause fire due to insulation failure caused by humidity. Disconnect the power plug and wipe with a dry cloth. ►In ► case of an abnormality or malfunction Immediately stop using and remove the adaptor if there is an abnormality or malfunction. - Failure to do so may cause fire, electric shock, or injury.
CAUTION Do not wrap the cord around the adaptor or the charging stand when storing. - Doing so may cause the wire in the cord to break with the load, and may cause fire due to short circuit. Disconnect the adaptor from the household outlet when not using. - Failure to do so may cause electric shock or fire due to electrical leakage resulting from insulation deterioration. Disconnect the adaptor or the appliance plug by holding onto the adaptor or the appliance plug instead of the cord.
WARNING If the battery fluid leaks out, do not touch the battery with your bare hands. - The battery fluid may cause blindness if it comes in contact with your eyes. Do not rub your eyes. Wash immediately with clean water and consult a physician. - The battery fluid may cause inflammation or injury if it comes in contact with the skin or clothes. Wash it off thoroughly with clean water and consult a physician. Intended use • This clipper is designed for professional use to trim hair.
I Charging stand (RC9‑87) Charging plug = Stand socket J AC adaptor (RE9‑73) Adaptor Power plug Cord Appliance plug Accessories K Cleaning brush L Lubrication Oil Charging the clipper • Make sure that the clipper is turned off. the appliance 1 Connect plug to the stand socket. the clipper on the 2 Place charging stand. the adaptor into a 3 Insert household outlet. 3 2 •• Charging is completed after approx. 1 hour. •• Check the charge status lamp ( ) glows.
Charging without the charging stand 1. Press the power switch to turn off the power, and insert the appliance plug into the clipper. 2. Plug in the adaptor into a household outlet. AC operation If you connect the AC adaptor to the clipper in the same way as for charging, and turn on the power, you can use it. • If the remaining battery is too low, the blades may move slowly or stop, even with the AC operation. In this case, charge the battery for 1 minute or more.
Using the comb attachments the trimming heights indicated on the 1 Select outside of the attachments. the dial to “0.8” and then 2 Set mount the attachment to the clipper until it clicks as illustrated. Care Removing and mounting the blade • Be sure to turn off the power before you remove the blade. Removing the blade Hold the clipper with the switch facing upward and push the blade with your thumb while catching the blade in your other hand. Mounting the blade 1. Set the dial to “2.0”.
Cleaning Clean the clipper and the blade after each use. (If not cleaned, the motion will become poor and the sharpness will worsen.) • Make sure that the clipper is turned off. 1. Brush off any hairs from the clipper and from around the blade. 2. Brush off the hairs from the blade edge. Lubrication • Apply lubrication oil to the blade before and after each use. Apply a drop of the lubrication oil to each indicated point.
Troubleshooting Problem Frequently asked questions Action Charge the clipper. (See page 8.) The clipper has become blunt. Clean the blade and apply lubrication oil. (See pages 10 and 11.) Replace the blade. (See pages 10 and 11.) Clipper stopped functioning. The clipper cannot be charged. Charge the clipper. Or use with the AC operation. (See page 8.
Removing the built-in rechargeable battery Remove the built-in rechargeable battery before disposing the clipper. Please make sure that the battery is disposed of at an officially designated location if there is one. This figure must only be used when disposing the clipper, and must not be used to repair it. If you dismantle the clipper yourself, it may cause malfunction. • Remove the clipper from the AC adaptor.
Disposal of Old Equipment and Batteries Only for European Union and countries with recycling systems These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries must not be mixed with general household waste. For proper treatment, recovery and recycling of old products and batteries, please take them to applicable collection points in accordance with your national legislation.
MEMO 15 ER-GP81_UK.
Panasonic Corporation http://www.panasonic.com © Panasonic Corporation 2017 Printed in Japan ER9710GP812F S0317-1047 F EN ER-GP81_UK.
