Operating Instructions
20
• See page 21 for removing the outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Attach the outer foil
self-cleaning recharger
[B]�
1. Insert the shaver into the
self‑cleaning recharger and
plug the adaptor into a
household outlet.
• Check that the charge status lamp (
) is
glowing.
2. Press
twice.
The DRY lamp glows, and the “Dry/Charge”
mode will start after approximately 6 seconds.
• It is possible to change to the “AUTO” mode
even after the “Dry/Charge” mode has started.
180 min
Charge
0 to 60 min
3. Remove the adaptor after the selected mode is
completed.
5
Lubricate the shaver�
1
2
1
It will keep the movement of the blade smooth and
maintain a comfort shave.
1. Apply one drop of oil to each of the system outer
foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Dry in a shade and apply oil.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
ES-LV97_EU.indb 20 2019/06/05 21:17:22