User Guide

- 187 -
This setting controls whether or not a password is required when you directly connect this unit and a
smartphone to start remote operations or to use the Wireless Twin Camera function.
≥ If you select [OFF], you can directly connect this unit and a smartphone without entering the
password for this unit’s SSID into the smartphone.
≥ If you select [OFF], you cannot set up a connection with [WPS Connection] or [QR code].
If your device is Android (non-NFC-compatible)/iOS, set up a connection by setting this unit’s
SSID on the smartphone. (l 181, 196)
≥ The default setting is [OFF]. If you perform [Reset Wi-Fi Settings], the default setting will be
restored. (l 38, 188)
You can use this unit as a Wireless Sub Camera.
For the connection procedure and other details, check the website below.
http://panasonic.jp/support/global/cs/e_cam
Please refer to page 190.
This item allows you to use NFC to turn on this unit, establish a remote connection, and configure
the home monitoring settings.
Please refer to page 161.
If you set [ON], the LCD monitor turns off when remotely operating this unit with a smartphone (in
Motion Picture Recording Mode or Still Picture Recording Mode) so that power consumption is
reduced.
≥ When the LCD monitor is turned off, you can display the screen by touching it.
≥ If the Wi-Fi connection is turned off, this unit will turn off automatically approximately 15 minutes
later.
[Direct Connection
Password]
[ON]/[OFF]
[Wireless Sub Camera]
[LUMIX CLUB]
[Start up using NFC]
[ON]/[OFF]
[Home Monitor Connect]
[ECONOMY (Wi-Fi)]
[ON]/[OFF]