User Guide

- 241 -
3 Press the recording start/stop button.
(When [Party Scene]/[Moving Object] is selected)
≥ Before recording starts, the Remote Pan Tilt Cradle rotates and returns to its home position. It
takes time until recording starts.
≥ The Remote Pan Tilt Cradle operates within the range set in advance.
(When [Manual]/[Preset Positions] is selected)
≥ Performing the operation of Step 2 during recording may cause the recording screen to shake or
the Remote Pan Tilt Cradle to move from its original location.
To switch the Remote Pan Tilt Cradle Mode
Tou ch .
≥ The selection screen of the Remote Pan Tilt Cradle Mode is displayed. Touch the desired mode.
To exit the Remote Pan Tilt Cradle
Tou ch [E X I T].
≥ The Remote Pan Tilt Cradle rotates and returns to its home position.
≥ After the operation, the Remote Pan Tilt Cradle turns off. Before removing this unit, disconnect
the USB cable.
∫ Registering positions to the position buttons
1 Touch .
2 Touch the position button to which you want to register a position.
≥ You can register positions to [POS1]/[POS2]/[POS3]/[POS4]/[POS5]
≥ The position buttons without a registered position are indicated as [Not set].
3 Determine a position with / / /
≥ You can also operate the zoom with the zoom lever.
4 Touch [ENTER].
≥ To register positions to other position buttons, repeat Steps 2–4.
≥ To adjust a position that has already been registered to a position button, touch the position
button to which the position you want to adjust is registered, and follow Steps 3–4.
∫ Moving the Remote Pan Tilt Cradle to a registered position
1 Touch .
≥ Check that is highlighted in yellow.
≥ The position buttons ([POS1]/[POS2]/[POS3]/[POS4]/[POS5]/[HOME]) will be displayed.
These buttons will disappear when no touch operation is performed for approximately 5 seconds.
To display them again, touch the screen.
2 Touch the desired position button.
≥ The Remote Pan Tilt Cradle will move to the registered position of the selected position button.
≥ You cannot select position buttons without a registered position.
≥ If you touch [CANCEL], the Remote Pan Tilt Cradle will stop in a midway position.
≥ To return to the home position, touch [HOME].
∫ Using Cycle Mode
In this mode, the Remote Pan Tilt Cradle cycles through positions registered to the position buttons
in the desired sequence.
The default sequence is as follows: [HOME] # [POS1] # [POS2] # [POS3] # [POS4] # [POS5]
Setting up [Preset Positions]
POS
POS