Operating Instructions

- 130 -
To switch the display order
1 Touch the access point you want to switch the order.
2 Switch the order by touching or .
≥ To change the wireless access point, delete one of the registered wireless access points, and
then add one.
Please refer to page 125.
This will disconnect the Wi-Fi connection.
You can enable/disable the NFC function.
This will set/clear the Password to limit the startup of the Wi-Fi setting menu.
By setting the Password, it will prevent erroneous operation, prevent wrongful use of the Wi-Fi
function by third party, and protect the set personal information.
1 Touch [Setup].
2 Touch [INPUT], and enter the Password (6 characters).
≥ After finish entering the Password, touch [Enter].
≥ If the Password has already been set, is displayed.
≥ For details on how to enter characters, refer to page 124.
3 Touch [NEXT].
4 Touch [INPUT], and enter the same Password again.
≥ After finish entering the Password, touch [Enter].
≥ If the Passwords match with each other, a message is displayed.
5 Touch [EXIT].
≥ If you set a Wi-Fi password, password entry is required each time you select [Wi-Fi Setup] from
the menu.
≥ When you forget your Wi-Fi Password, set this unit to Recording Mode, select [Wi-Fi] in [INITIAL
SET], and make the initial Wi-Fi settings. (l 160) This will set the Wi-Fi setting to the condition at
the time of purchase, and you will be able to use the Wi-Fi setting menu.
[Direct Connection]
[Wi-Fi disconnect]
[Start up using NFC]
[ON]/[OFF]
[Wi-Fi Password]
[Setup]/[Delete]