Operating Instructions

- 40 -

∫ To emphasise the outline of images

Setting [EVF/LCD DETAIL] to [ON] helps you achieve focus easier by emphasizing the outlines of

an image displayed on the LCD monitor and viewfinder.

You can also adjust the emphasis level or change the frequency.

≥ You can also enable or disable this function with the applicable USER button. (l 61)

≥ These settings will not affect the images actually recorded.

Adjusting the level of [EVF/LCD DETAIL]

1 Select the menu.

2 Touch / to adjust settings.

3 Touch [ENTER].

≥ Touch [EXIT] to exit the menu screen.

Setting the peaking frequency of [EVF/LCD DETAIL]

≥ [EVF/LCD DETAIL] is cancelled in following cases:

j If you use Focus Assist (l 40)

Push AF

When using Manual Focus, you can temporarily use Auto Focus by pressing the PUSH AF button.

1 Set this unit to Manual Focus. (l 39)

2 Press and hold the PUSH AF button.

≥ The focus position will be automatically adjusted for the subject at the centre of the screen.

≥ If you set [AREA MODE] to [FOCUS], [FOCUS/IRIS] or [FOCUS/Y GET] and use Area Mode, the

focus position will be automatically adjusted to the subject you have touched. (l 68)

≥ It will be cancelled when the button is released.

≥ The focus position set by the Push AF will be maintained when cancelled.

≥ Push AF does not work in following cases:

j In Intelligent Auto Mode

j When the FOCUS A/M/¶ switch is set to [A]

j When a remote control (commercially-available) is connected (l 6)

Focus Assist

You can use Focus Assist by registering [FOCUS ASSIST] to a USER button.

≥ This function is registered to the USER5 button by default.

≥ Please refer to page 61 for details about setting the USER button.

: [DISP SETUP] # [EVF/LCD DETAIL] # [ON]

: [DISP SETUP] # [EVF/LCD PEAK LEVEL]

: [DISP SETUP] # [EVF/LCD PEAK FREQ.] # [HIGH] or [LOW]