Operating Instructions

Chapter 10 Notes — Warning system
- 187 -
Message
Screen display
Description Behavior and cause
Camera image screen
[CANNOT PLAY.] This is a clip that cannot be played back.
(When it cannot be played back due to difference of the
system frequency, etc.)
An error has occurred during playback, and the playback
has stopped.
≥ Confirm if the system frequency of the clip is the same as
the system frequency of the unit.
≥ Check the clip.
[CANNOT DELETE.] This is a clip that cannot be deleted.
≥ Match the device and content versions.
[CANNOT RECORD. THE NUMBER
OF CLIPS HAS EXCEEDED THE
MAXIMUM LIMIT.]
The number of clips that can be recorded has reached the
maximum.
≥ Replace the memory card or delete unnecessary clips.
[CARD ERROR. PLEASE
REFORMAT.]
Formatting of the memory card has failed.
≥ Format it again.
[CANNOT COPY TO SAME CARD.] The clip recorded over multiple memory cards cannot be
copied to a same card.
≥ Copy to a card not containing a clip that is recorded over
multiple memory cards.
[Repair failed.] Repairing the clip where an error occurred has failed
because the power was disconnected or the memory card
was removed during recording.
Restoring of the management information has failed.
≥ Check the memory card.
[UNABLE TO FORMAT.] This memory card cannot be formatted.
≥ Check the memory card.
[CANNOT PROTECT.] This is a clip that cannot be protected.
≥ Match the device and content versions.
[THE CLIP IS PROTECTED. PLEASE
CANCEL PROTECTION.]
The clip is protected so it cannot be deleted.
≥ Cancel the protect on the clip.
[THUMBNAIL DATA ERROR IS
DETECTED.]
An error occurred in the thumbnail information of the
memory card.
≥ Restoring of the management information is performed
automatically after this.
[CANNOT RECORD -
INCOMPATIBLE CONTROL DATA.]
The version of the management information on the
memory card is not supported.
≥ Match the device and content versions.
[CANNOT SET.] This cannot be set.
≥ Perform the setting after making it possible to set.
[THIS CLIP CANNOT BE COPIED.] The clip cannot be copied.
≥ Copy the clips other than the corresponding clip.
[CONTROL DATA ERROR HAS
BEEN DETECTED. (SD CARD)]
An error occurred in the management information of the
memory card.
≥ Restoring of the management information is performed
automatically after this.
[COPY FAILED. PLEASE CHECK
THE CARD.]
The clip has failed to copy due to an error in the memory
card.
≥ Check the memory card.
[CANNOT COPY - THE NUMBER OF
CLIPS HAS REACHED MAXIMUM.]
The number of clips that can be copied has reached the
maximum.
≥ Replace the memory card in the copy destination or delete
unnecessary clips.
[LOW BATTERY. PLEASE CONNECT
AC ADAPTOR OR CHANGE
BATTERY.]
It is trying to copy a clip or update the firmware of the unit
when the remaining battery level is insufficient.
≥ Replace with a fully charged battery, or connect the AC
adaptor.
[CANNOT PLAY THIS CLIP ON THIS
MODEL.]
This is a clip that cannot be played back with the unit.
≥ Playback on a device that can playback.
[Cannot copy: contains recordings
from other devices.]
The clip recorded in other device cannot be copied.
≥ Copy the clips other than the corresponding clip.
[INVALID] Operation is disabled.
≥ Operate after the operation becomes enabled.
[Cannot record - Playlist capacity is
full.]
The unit tried to record on a memory card where the
number of playlists for recording has reached the
maximum.
≥ Replace the memory card or delete unnecessary clips.
[Cannot copy - Playlist capacity is full.] The unit tried to copy to a memory card where the number
of playlists for recording has reached the maximum.
≥ Replace the memory card or delete unnecessary clips.
[Exceeds capacity. Please reselect.] The remaining recording capacity of the memory card for
the copy destination is insufficient.
≥ Select the clip to copy again, or secure enough space in
the remaining recording capacity on the memory card for
the copy destination.
[Check the destination media.] An error has occurred on the memory card for the copy
destination while copying.
≥ Confirm the memory card for the copy destination.
[LOAD NG] Loading of the scene file has failed.
≥ Check the memory card.
[SAVE NG] Writing of the scene file has failed.
≥ Check the memory card.
[DISCONNECT USB CABLE.] Due to an OS non-compatible error, 5 minutes has elapsed
until the service mode connection is established.
≥ Confirm if the OS in use is supported by the unit.
[CARD LOCKED.] The unit tried to protect or delete a clip on a memory card
that has been locked.
The unit tried to copy a clip to the memory card that has
been locked.
≥ Unlock the memory card.
[CANNOT SELECT MORE CLIPS.] It has tried to select more than 99 clips.
≥ Execute the process such as copying by every 99 clips.
[SELECT THE CLIP TO BE
DELETED.]
It has tried to delete a clip without choosing any.
≥ Select a clip to be deleted.
[SELECT THE CLIPS TO COPY.] It has tried to copy a clip without choosing any.
≥ Select a clip to be copied.