Operating Instructions

- 81 -
2 Turn on the unit.
≥ Turn on with the unit in a horizontal state.
≥ The 3D Conversion Lens adjustment mode screen will appear automatically after
performing the initial setting.
≥ If the 3D Conversion Lens adjustment mode screen does not appear automatically,
set from the menu.
([SETUP] # [3D CONV. LENS SETUP])
≥
If the unit is turned on with the USB cable still connected, the USB connection will take priority.
3 Adjust the 3D Conversion Lens attachment part following the
instructions on the screen.
≥ //
The 3D Conversion Lens cannot be adjusted using the viewfinder.
4 Touch [EXIT] to end the adjustment.
≥ //
Display of the LCD monitor is switched to 3D.
≥ When re-attaching the 3D Conversion Lens or after an impact etc., it is recommended that
you perform the adjustment again.
5 (When recording motion pictures)
Press the recording start/stop button to start recording. (l 24)
≥ Start recording after removing the Lens front cap.
≥ [REC MODE] during recording the 3D will be [AVCHD 3D] or [SbS 3D]. (l 59)
(When recording still pictures)
Press the button to record still pictures. (l 26)
≥ appears on the screen.
≥
It is possible to record still pictures while recording motion pictures. (Simultaneous recording)
≥ The number of recording pixels are (1920k1080). (l 71)
HC-X900
HC-X909
HC-X900M
HC-X900
HC-X909
HC-X900M
3D
2.1
M
HC-X900&X900M&X800EP-VQT4D01_mst.book 81 ページ ２０１２年１月１２日 木曜日 午前１０時４４分