Operating Instructions

- 82 -
∫ //
To switch the image during the recording to 2D (3D) display
≥ Touch (left side)/ (right side) of on the Touch Menu to display ( ). ( l 20)
≥ ( ) is displayed only when the 3D Conversion Lens (optional) is attached.
Touch ( ).
≥ 2D (3D) image will switch to 3D (2D) image.
≥ It is possible to set from the menu.
([SETUP] # [2D/3D DISPLAY])
≥ Use of a tripod is recommended for recording with a stable picture.
≥ //
The reception range for the remote control might become narrow at the upper side of the
unit, so operate from the lower side. (l 44)
≥ [ECONOMY (BATT)]/[ECONOMY (AC)] will not work while you adjust the 3D Conversion
Lens attachment position.
≥ When the 3D Conversion Lens is attached, the auto slow shutter setting is [AUTO SLOW
SHTR (3D)]. The default setting of [AUTO SLOW SHTR (3D)] is [ON]. (l 64)
≥ While 3D recording if moving the unit fast, the message is more likely to appear.
≥
The LCD monitor on this unit will not display in 3D.
≥ If the unit is turned on with the lens cap attached in the shade etc., the screen may appear
to be blue. In such a case, remove the lens cap to return the screen to normal.
To ensure that the 3D image can be safely viewed, pay attention to the following
points when recording.
≥ Where possible, record with the unit in a horizontal state.
≥ Do not get too close to the subject. (record from a distance of at least 1.2 m.)
≥ When moving the unit as you record, move it slowly.
≥
Try to hold the unit as steady as possible when recording while riding in a vehicle or walking.
HC-X900
HC-X909
HC-X900M
MENU
Q.
MENU
HC-X900
HC-X909
HC-X900M
HC-X800
HC-X900&X900M&X800EP-VQT4D01_mst.book 82 ページ ２０１２年１月１２日 木曜日 午前１０時４４分