Operating Instructions

- 37 -

The unit is put into recording pause approx. 1 second when the unit is turned on with the mode set

to or .

≥ Depending on the recording conditions, start time may be longer than 1 second.

≥ In the Quick Power On Mode, the zoom magnification becomes approx. 1k.

This unit is put into recording pause approx. 0.6 seconds after the LCD monitor is reopened or the

viewfinder is extended.

≥ When in Quick Start Standby Mode about 70% of the power used in recording pause mode

is being consumed, so the recording time will be reduced.

≥ //

Quick Start will not work if there is no SD card inserted.

Quick Start will not work if the [SD CARD] is selected in the [MEDIA SELECT], even if there is no

SD card inserted.

1 Select the menu.

2 Close the LCD monitor and retract the

viewfinder.

The status indicator A flashes green and the unit goes into

Quick Start Standby Mode.

≥ The lens cover does not close.

3 Open the LCD monitor or extend

the viewfinder.

The status indicator A lights red and the unit

is put into recording pause.

≥ Quick Start Standby Mode is cancelled if

j about 5 minutes elapsed

j mode is set to

≥ Depending on the recording conditions and menu settings, time for Quick Start may be longer

than 0.6 seconds.

≥ It may take some time for Automatic White Balance to adjust.

≥ In the Quick Start Mode, the zoom magnification becomes approx. 1k.

≥ If [ECONOMY (BATT)] (l 36)/[ECONOMY (AC)] (l 36) is set to [ON] and the unit automatically

goes into Quick Start Standby Mode, close the LCD monitor and viewfinder and then open the

LCD monitor or extend the viewfinder again.

≥ Turn the unit off using the power button.

[QUICK POWER ON]

: [SETUP] # [QUICK POWER ON] # [ON]

[QUICK START]

: [SETUP] # [QUICK START] # [ON]

HC-X920

HC-X929

HC-X910

HC-X920M

