Operating Instructions

- 185 -
Ostalo
Rješavanje problema
Nije riječ o kvaru u sljedećim slučajevima
Kada se uređaj protrese,
čuje se škljocanje.
Radi se o zvuku pomicanja objektiva i ne radi se o pogrešci.
Ovaj se zvuk više neće čuti kada se uređaj uključi i način
rada prebaci na ili .
Objekt izgleda izobličeno. Objekt može izgledati donekle izobličeno, ako se brzo kreće
preko kadra, ali to je stoga što kamera koristi MOS kao
senzor slike. Nije riječ o kvaru.
Na snimljenoj fotograji
pojavljuju se bijele okrugle
točke slične balonima od
sapunice.
Snimite li fotograju s
bljeskalicom na tamnome
mjestu ili u zatvorenom
prostoru, na fotograji se
mogu pojaviti bijele okrugle
točke, a uzrok je odbijanje
svjetla bljeskalice od čestica
prašine u zraku. Nije riječ
o kvaru.
Karakteristika ove pojave jest da se broj okruglih točki i njihov
položaj razlikuju na svakoj fotograji.
Zamagljen je objektiv ili
LCD-monitor.
Do toga dolazi zbog kondenzacije. Ne radi se o kvaru.
Detalje potražite na 3. str.
Napajanje
Problem Provjere
Uređaj se ne može
uključiti.
Uređaj ne ostaje dovoljno
dugo uključen.
Baterija se brzo prazni.
Ponovno napunite bateriju da bi bila dovoljno puna. (→ 11)
Na hladnim mjestima vrijeme korištenja baterije postaje
kraće.
Vijek trajanja baterije ograničen je. Ako je vrijeme korištenja
baterije i dalje prekratko, čak i ako se baterija napuni do
kraja, tada je baterija dotrajala i potrebno ju je zamijeniti.
Uređaj se automatski
isključuje.
Ako se uređaj isključi nakon što daljinskim upravljačem
isključite TV-prijamnik, funkcija VIERA LINK je uključena. Ako
ne koristite funkciju VIERA Link, podesite [VIERA Link] na
[OFF] (isklj.). (→ 113)
Uređajem se ne može
rukovati, iako je uključen.
Uređaj ne radi pravilno
Uklonite bateriju ili isključite prilagodnik za izmjeničnu struju,
pričekajte otprilike 1 minutu i ponovno umetnite bateriju ili
prilagodnik za izmjeničnu struju. Otprilike 1 minutu nakon
toga ponovo uključite uređaj (ako se gore opisana radnja
izvodi za vrijeme dok uređaj pristupa mediju, može doći do
oštećenja podataka na mediju).
Ako niti nakon toga rad s uređajem nije normaliziran,
odspojite napajanje i obratite se trgovcu od kojega ste kupili
uređaj.
- 185 -
It is not a malfunction in following cases
Others
Troubleshooting
A clicking sound is heard
when the unit is shaken.
This is the sound of the lens moving and is not a defect.
This sound will no longer be heard when the unit is turned on
and change the mode to or .
Object seems to be warped. Object seems to be warped slightly when the object moves
across the image very fast, but this is because the unit is using
MOS for the image sensor. This is not a malfunction.
White round spots like soap
bubbles appear on the
recorded picture.
If you take a picture with the
flash in a dark place or
indoors, white round spots
may appear on the picture
caused by the flash reflecting
of particles of dust in the air.
This is not a malfunction.
A characteristic of this is that the number of round spots and
their position differ in every picture.
The lens or LCD monitor
fog up.
This is due to condensation. It is not a malfunction. Please
refer to page 3.
Power
Problem Check points
This unit cannot be turned
on.
This unit does not stay on
long enough.
Battery runs down quickly.
Charge the battery again to ensure it is sufficiently charged.
(l 11)
In cold places, the battery using time becomes shorter.
The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and needs to be replaced.
This unit is turned off
automatically.
If the unit turns off when you turn off the power to the TV
using the TV remote control, the VIERA Link is at work. If you
are not using the VIERA Link, set [VIERA Link] to [OFF].
(l 113)
This unit cannot be
operated though it is
turned on.
This unit does not operate
normally.
Remove the battery or AC adaptor, wait about 1 minute and
then reconnect the battery or AC adaptor. Then about 1
minute later, turn on the unit again. (Conducting the above
operation while the media is being accessed may damage the
data on the media.)
If normal operation is still not restored, detach the power
connected, and consult the dealer who you purchased this
unit from.