Operating instructions

37
VQT1G66
Setup
release it. A repair disc message may be
displayed when the power is turned back on.
(l 137)
≥ Do not insert anything other than the 8 cm
DVD-RAM, DVD-RW, DVD-R or DVD-R DL
disc into the disc compartment. Doing so could
cause malfunctions. (l 21)
≥ Do not touch the pickup lens or other parts
inside the disc compartment. Be sure not to
touch the area around the pickup lens for it
becomes extremely hot.
Inserting/removing an SD
card
Be sure to set the mode dial to OFF before
inserting/removing an SD card.
1 Set the mode dial to OFF.
≥ Check that the status indicator has gone off.
2 Open the card slot cover.
3 Insert/remove the SD card into/
from the card slot.
≥ When inserting an SD card, face the label side A
upwards and press it straight in as far as it goes.
≥ When removing the SD card, press the centre
of the SD card and then pull it straight out.
4 Securely close the card slot cover.
After inserting a disc/After recording
finishes
While the ACCESS/PC lamp is lit, the disc is
rotating and disc information is being
recorded. If the power supply is interrupted at
this time, the disc may become unusable. Do
not disconnect the AC adaptor or remove the
battery. Also, do not strongly shake or cause
impact to the unit.
If the SD card is inserted or removed while the
power is on, this unit may malfunction or the
data recorded on the SD card may be lost.
HDC-SX5-VQT1G66_mst.book 37 ページ ２００７年７月２４日 火曜日 午後５時５６分