Operating instructions

47
VQT1G66
Setup
Adjusting LCD monitor/
viewfinder
1 Press the MENU button, then
select [SETUP]
# [LCD SET] or
[EVF SET]
# [YES] and press the
cursor button.
2 Move the cursor button up or
down to select the item to be
adjusted. Then, move the cursor
button left or right to make the
adjustment.
≥ (HD mode) Move the cursor button to select
the item to be adjusted. Then, press the centre
of the cursor button to set and then move the
cursor button to make the adjustment.
The bar display moves.
≥ (HD mode) After adjustments are made if no
operations are performed for about 2 seconds,
the bar will disappear.
≥
Press the MENU button to exit the menu screen.
[LCD SET]
[BRIGHTNESS]:
Brightness of the LCD monitor
[COLOUR]:
Colour level of the LCD monitor
[EVF SET]
[BRIGHTNESS]:
Brightness of the viewfinder
≥ To adjust the brightness of the viewfinder,
extend the viewfinder and close the LCD
monitor to activate it.
≥ When the viewfinder is extended and the LCD
monitor is rotated by 180° towards the lens, the
brightness and colour level of the LCD monitor
cannot be adjusted.
≥ These settings will not affect the images
actually recorded.
ª In order to increase the
brightness of the entire LCD
monitor
Press the POWER LCD EXTRA
button.
The [ ] indication appears on the LCD
monitor.
≥ Each time the POWER LCD EXTRA button is
pressed, the indication changes by one setting
in the following order: [ ] > [] > setting
cancelled (standard)
≥ Press the POWER LCD EXTRA button if the
surroundings are bright and the LCD monitor is
difficult to see. The entire LCD monitor will
become brighter than usual.
≥ This will not affect the images to be recorded.
≥ If you use the AC adaptor, the [ ] indication
appears and the screen becomes brighter
automatically when the power is turned on.
Adjusting the brightness and
colour level
POWER LCD
EXTRA
1
+
1
+
2
+
1
+
HDC-SX5-VQT1G66_mst.book 47 ページ ２００７年７月２４日 火曜日 午後５時５６分