Operating Instructions

45
VQT2N56
The amount of space left on the SD card, the built-in memory and HDD can be checked.
(Only when the mode is at the position)
≥ Touching [CHANGE MEDIA] switches the unit between the display for the SD card and the
display for the built-in memory/HDD.
≥ Touch [EXIT] or press the MENU button to close the indication.
≥ The SD card, built-in memory or built-in HDD requires some space to store information and
manage system files, so the actual usable space is slightly less than the indicated value.
The usable built-in memory/HDD space is generally calculated as 1 GB=1,000,000,000
bytes. The capacities of this unit, PCs and software are expressed as
1 GB=1,024k1,024k1,024=1,073,741,824 bytes. Therefore, the indicated value of the
capacity appears to be smaller.
Perform the touch screen calibration if a different object to the one touched is selected.
1Touch [CALIBRATION].
≥ Touch [ENTER].
2 Touch the [+] that appears on the screen with the supplied stylus pen.
≥ Touch [+] in sequence (up left # down left # down right # up right # centre).
3 Touch [ENTER].
≥ Calibration cannot be performed when the LCD monitor is turned 180o.
≥ This item is used to start the unit demonstration.
(Only when the mode is at the or position)
If [DEMO MODE] is switched to [ON] when there is no SD card inserted, the demonstration
automatically starts.
/
If [DEMO MODE] is switched to [ON] when there is no SD card inserted and while this unit is
connected to the AC adaptor, the demonstration automatically starts.
If any operation takes place, the demonstration is cancelled. However if no operations take
place for approx. 10 minutes, the demonstration automatically starts again. To stop the
demonstration, set [DEMO MODE] to [OFF] or insert an SD card.
/
[MEDIA STATUS]
[CALIBRATION]
[DEMO MODE]
[OFF]/[ON]