Datasheet
23
PRECAUTIONS FOR PROPER USE
• This product is classied as a Class 2 Laser
Product under IEC / JIS / GB standards and
FDA* regulations. Do not look at the laser
beam directly or through an optical system
such as a lens.
• The warning label (English) is attached to the
product. Handle the product according to the
instruction given on the warning label.
(The warning labels in Japanese and
Chinese are packed with the sensor.)
* This product complies with 21 CFR 1040.10 and 1040.11 Laser Notice No.
50, dated June 24, 2007, issued by CDRH (Center for Devices and
Radiological Health) under the FDA (Food and Drug Administration).
Mounting
• When mounting this product, use M3 screws.
The tightening torque should be 0.5 N·m.
Please prepare M3 screws separately.
M3 screws
(prepare separately)
18 mm
0.709 in
37 mm
1.457 in
Mounting hole dimensions
Note: Due to the simple mounting bracket, the sensing characteristics may
not be hold depending on the installation condition, in case of the
purposes for acquiring the displacement data and a ne detecting.
• When mounting the simple mounting bracket (optional) on
this product, the tightening torque should be 0.5 N·m or less.
Plate
(Accessory for
MS-HG-01)
Simple mounting bracket
MS-HG-01 (Optional)
M3 (length 25 mm 0.984 in)
screws with washers
(Accessory for MS-HG-01)
Mounting direction
• Direction to a movable body
<When there are differences in material and color>
• When performing measurements of moving objects with
excessively different materials and colors, mount the
product per the following directions to minimize
measurement errors.
<Correct>
<Correct>
<Correct>
<Correct>
<Correct>
<Incorrect>
<Incorrect>
<Incorrect>
<Incorrect>
<Incorrect>
<When there is a step>
• When there is a step in the moving object, mount the
product as follows. Measurement can be performed with
minimized effect from the edges of the steps.
<Measurement of rotating objects>
• When measuring rotating objects, mount the product as
follows. Measurement can be performed with minimized
effect on the object caused by up / down deection,
position deviation and etc.
• When mounting the product on a wall
• Mount the product as follows, so that the multiple light
reections on the wall do not emit to the light-receiving
part. When the reection factor on a wall is high, it is
effective to use a dull black color.
Others
• This product has been developed / produced for industrial
use only.
• There is a certain deviation in the directionality of this
product. Install the product using a mounting bracket or
similar tting to allow the adjustment of optical axis.
• The internal memory (nonvolatile) of this product has a
service life. Settings cannot be congured more than
100,000 times.
• Measuring of narrow locations and recesses
• When measuring in narrow locations or inside holes,
mount the product so that optical path from the light-
emitting part to light-receiving part is not interrupted.
• Never use this product as a sensing device
for personnel protection.
• In case of using sensing devices for
personnel protection, use products which
meet laws and standards, such as OSHA,
ANSI or IEC etc., for personnel protection
applicable in each region or country.
• Do not operate products using methods other
than the ones described in the instruction
manual included with each product. Control
or adjustment through procedures other than
the ones specied may cause hazardous
laser radiation exposure.
CMOS Type Micro Laser Distance Sensor HG-C1000L SERIES
HG-C1000L
SERIES
• This catalog is a guide to select a suitable product. Be
sure to read instruction manual attached to the product
prior to its use.