Operating instructions

English
53 EN
Installation
• Veneer or other nish of the furniture the appliance is being built into should be
processed with heat-resistant glue (100°C); otherwise, high temperatures may
cause them to deform.
• There must be no rear wall tted to appliance housing.
• There must be a gap of at least 45 mm between the wall and the back of the unit
to enable adequate air circulation.
• The tted cabinet must have a ventilation opening of 50 cm
2
on the front. To
achieve this, cut back the plinth or t a ventilation grille. Ventilation slots and
intakes must not be covered.
• Level the piece of furniture the appliance was built into with a spirit level.
• The piece of kitchen furniture the appliance is built into must be secured against
movement, e.g. attached to the adjacent pieces of kitchen furniture.
• Align the appliance ush with the units and screw it in place.
• When attaching the appliance, make sure the screws are not fastened too
strongly as this may damage the furniture or the appliance.
• The ventilation slots and air intake points must not be covered. To ensure that
they remain uncovered also observe the installation instructions of any appliance
installed with this oven.
Installing the Appliance
NOTE
■ Ensure that the connector lead does not become trapped or bent.
■ After installation the connector lead must not be in contact with the back or
the base of the appliance.