Operating Instructions
4
SQT1200
– When attaching or removing the lens, be careful so that
foreign objects such as sand, dust, and water droplets
do not adhere to or enter the lens mount rubber, contact
points, digital camera and lens.
– If the lens is exposed to water droplets or other liquids,
wipe them off with a soft, dry cloth.
– When using the built-in slide lens hood, ensure that
particles such as sand and dust do not stick to the
lens barrel, where the built-in slide lens hood slides.
• To improve the dust and splash resistant performance of
the lens, a lens mount rubber is used in the mount.
– The lens mount rubber will leave scuff marks on the
digital camera mount, but this does not impact
performance.
– For information on changing the lens mount rubber,
contact Panasonic.
∫ About Condensation (Fogging of the Lens)
• Condensation occurs when there are differences in
temperature and humidity as described below.
Condensation can cause the lens to become dirty and
lead to mold and malfunctioning, so exercise caution in the
following situations:
– When the camera is brought indoors from outside during
cold weather
– When the camera is brought into an air-conditioned car
– When cold air from an air conditioner is directly blown
onto the lens
– In humid places
• If condensation occurs, turn the power off and leave it for about
two hours. Once the camera acclimatizes to the surrounding
temperature the condensation will go away naturally.
Supplied Accessories
Product numbers correct as of January 2016. These may
be subject to change.
1 Lens Pouch
2 Lens Hood
3 Lens Cap
4 Lens Rear Cap
5 External tripod mount
• The lens rear cap and lens cap are attached to the
interchangeable lens at the time of purchase.
SFC0360
1ZE4Z233CXZ
2GE8Z233CXZ
1GE2Z233CXZ
21
5
34
VFC4605
SQT1200_E.book 4 ページ ２０１９年６月１０日 月曜日 午後５時５６分