User manual

High−level Instructions
3 − 336
Specifications for each item
The control data specified by [S1][S1+1] is specified as follows.
[S1]: Specifying transmission unit and transmission method
Specifies No. of transmission words
H001 to H1FB (1 to 507): when transmitting to Group A
H001 to H18 (1 to 24)*: when transmitting to Group B
H1FB is 507 words. H18 is 24 words.
Word unit
transmission
[S1]:
H0
Group A
FPΣ,FP−X, FP0R, FP2,
FP2SH, FP10SH
Group B FP0, FP−e
* However, if either SV or EV is specified for the remote unit’s device No. of [D], up to H19 (25) words is
available.
Bit No. of local
unit (H0 to HF)
Bit No. of remote
unit (H0 to HF)
[S1]:
Bit unit
transmission
H0 fixedH8
[S1+1]: Specifying the remote unit
Unit No. (H00 to H63)
(0 to 99)
[S1+1]:
H0 fixed
Selects COM port
(H1 or H2)
(1) Specifying the transmission unit and transmission method [S1]
If data is to be sent in word units, specify the data volume, and if it is to be sent in bit units, specify the position of the
target bit.
(2) Specifying the remote unit [S1+1]
Specify the remote unit with the unit number. When H00, it is global transmission. (No response)
Specify either the COM1 or COM2 port from which data is transmitted to the remote unit.
Specify H1 if only one COM port is available.
(3) Specify the area of the local unit by [S2] in which the data to be transmitted is stored
Specify the memory area of the local unit in which the data to be transmitted is stored.
(4) Specify the area of the remote unit for storing by [D] and [N].
Specify 0 for the device No. of [D].
Specify the memory area of the remote unit in which the data to be transmitted is stored, specifying the type D and the
address N in combination.
[D]:DT0, [N]:K100
DT100
Example)
For the FP0R, FPΣ V3.20 or later, FP−X V2.50 or later, transmission can be performed without checking when DT0 or
LD0 is specified for D, and H constant is specified for N.
(Example) In case of DT0 and HFFFF, it is possible to access DT63353. It is convenient to access the data registers
of an eco−power meter KW8M.
The MEWTOCOL−COM command is created according to the operands specified by [S1],[S1+1], [S2],
[D], and [N].
FPΣ/FP−X/FP0R