User manual

High−level Instructions
3 − 431
Flag conditions
・Error flag (R9007) (R9008):
− It turns on, when the specified address using the index modifier exceeds a limit.
− It turns on, when the MCU unit does not exist in the slot No. specified by [D].
− It turns on, when the MCU unit does not exist in the slot No. specified by [D]
− It turns on, when the data device specified by [S] exceeds the area.
− It turns on, when the transmitted byte number specified by [n] is outside of
the specified area.
− It turns on, when the transmitted byte number specified by [n] exceeds the
area of the data table.
− It turns on, when H8000 is designated in the PC link mode.
− It turns on, when an additional parameter is registered in executing the
parameter registration.
− It turns on, when H8000 is designated in the parameter registration.
− It turns on, when a negative value is designated in the parameter
registration.
FP2/FP2SH