Operation Manual

of anchor appropriate for the
installation location and
materials.
R Do not install on gypsum board
or concrete blocks.
Installing the camera
1 O
pen the interface cover (A),
and then slide the power slide
switch to ON (B).
2 Close the interface cover (C).
3 Secure the safety wire ring to
the camera nut of the camera
using a driver (D), and then
pass the safety wire through
the ring of the safety wire ring
(E).
4
5
1
2
3
Important:
R M
ake sure to close the
interface cover securely.
Water resistance cannot
be assured if the interface
cover is open.
4 Drive the wall mounting
screws into the wall.
1
Longer than 25 mm (1 inch)
2
Space 2.8 mm (
1
/8
inches)
1 2
Note:
R U
se the following template
when determining the
location of the screw holes.
(1 inch)
25.4 mm
5 M
ount the wall mounting
adaptor to the wall. Next,
attach the safety wire to the
wall, and then attach the
camera to the wall mounting
adaptor.
1
Wall mounting screws
2
25.4 mm (1 inch)
For a
ssistance, please visit http://shop.panasonic.com/support
19
Setup
HNC710_(en_en)_0207_ver.110.pdf 19 2018/02/07 20:11:47