Cordless Telephone User Manual

To record your own greeting
message with function menu
1 Press (INT) then .
2 Press or until the arrow points
to “Record”, then press .
3 While “Record OGM” is at the arrow,
press .
4 After the long beep, talk clearly, about
20 cm away from the MIC (microphone)
on the handset.
•During recording, the arrow points to
“Stop”.
5 When finish recording, press .
•A recorded your own greeting message is
played back.
•
The display will return to “Remote
Operation”. To return to the standby
mode, press or wait for 30 seconds.
Chapter 5
Answering System
67
Answering System Operations
For basic answering system operation, see page 13.
You can operate the answering system by function menu or by pressing dialling button as direct
command.
All messages (greeting, incoming, and memo) are stored indefinitely on a “Flash memory”
IC chip – even if a power failure occurs. All of the messages are saved until you erase them – Flash
Memory Message Backup.
Greeting Message
The total recording time is approximately 15 minutes. Any recorded noise may shorten the
recording time up to 3 minutes. The greeting recording time is limited to 2 minutes and 30
seconds. We recommend you to record a brief greeting message in order to leave more time
for recording new incoming/memo messages.
To record your own greeting
message with direct command
1 Press (INT) then .
2 Press then .
3 After the long beep, talk clearly, about
20 cm away from the MIC (microphone)
on the handset.
•The display will start showing the length of
the recording time.
5 When finish recording, press .
•A recorded your own greeting message is
played back.
•The display will return to “Remote
Operation”. To return to the standby
mode, press or wait for 30
seconds.
9
6
7
Record
Answer ON
H
Stop
Remote Operation
76
00-00
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
KX-TCD725EM-4(65~85) 01.10.24 14:39 Page 67