Cordless Telephone User Manual

74
Setting the Monitor Function ON/OFF
When your greeting message is being played to the caller, you can listen to it through the handset.
To listen to your greeting, set to 2 (ON). The factory preset is 2 (ON).
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press .
•“Remote Operation” is displayed.
4 Press .
•The current setting is displayed.
5 To set to ON, press .
OR
To set to OFF, press .
•The setting is displayed.
6 Press .
•The display will return to “Setting
Base”. To return to the standby mode,
press .
1
2
4
Answering System Operations
Selecting the Caller’s Recording Time
You can select “1 minute”, “unlimited (16 minutes)” or “greeting only” for the caller’s recording time.
The factory preset is “unlimited”. A pre-recorded greeting message (p. 13) depends on selecting the
caller’s recording time. If you select “greeting only” and set the answering system ON, the unit will
answer a call with the greeting message, then hang up. The unit does not record any incoming
messages.
Make sure that the power is ON (p. 12), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press .
•“Remote Operation” is displayed.
4 Press .
•The current setting is displayed.
3
5 Press , or to select the
recording time.
1: 1 minute 2: unlimited 3: greeting only
•The setting is displayed.
6 Press .
•The display will return to “Setting
Base”. To return to the standby mode,
press .
3
2
1
KX-TCD725EM-4(65~85) 01.10.24 14:39 Page 74