Operation Manual

Programming
22
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Special programming
Alarm
You can set one of 2 different alarm
options (once or daily) at a time for each
handset. An alarm sounds at the set time
for 3 minutes.
Important:
L Set the date and time beforehand
(page 15).
1 8 (middle soft key)
2 {V}/{^}: Handset Setup i
M
3 {V}/{^}: Time Settings i
M
4 {V}/{^}: Alarm i M
5 {V}/{^}: Select the desired alarm
option. i M
6 Set the desired time. i M
7 {V}/{^}: Select the desired alarm
tone. i M 2 times
L We recommend selecting a
different ringer tone to the one
used for outside calls.
8 {ih}
L When the alarm is set, E is
displayed.
Note:
L You can skip to step 4 by pressing
{R/E} in standby mode.
L To stop the alarm, press any dial key
or place the handset on the base unit
or charger.
L When the handset is in use, the alarm
will not sound until the handset is in
standby mode.
L If you select Once, the setting
changes to Off after the alarm
sounds.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, see page 41.
1 8 (middle soft key)
2 {V}/{^}: Base Unit Setup i
M
3 {V}/{^}: Base Unit PIN i
M
4 Enter the current 4-digit base unit
PIN (default: 0000).
5 Enter the new 4-digit base unit PIN.
i M i {ih}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
Off
Turns alarm off. Press M again,
then press {ih} to exit.
Once
An alarm sounds once at the set
time. Enter the desired date and
month. i M
Daily
An alarm sounds daily at the set time.
Available for:
KX-TG6421/KX-TG6422/
KX-TG6423/KX-TG6424
TG6411-6421E(e).book Page 22 Tuesday, December 16, 2008 7:54 AM