TGA939(e).fm Page 1 Friday, June 27, 2008 5:40 PM Installation Manual Additional Digital Cordless Handset Model No. KX-TGA939 Thank you for purchasing a Panasonic digital cordless phone. This unit is an additional handset compatible with the following Panasonic Digital Cordless Phones: KX-TG9391/KX-TG9392 You must register this handset with your base unit before it can be used. This installation manual describes only the steps needed to register and begin using the handset.
TGA939(e).fm Page 2 Friday, June 27, 2008 5:40 PM Supplied accessories Accessory item/Order number Quantity Charger/PNLC1001YT 1 AC adaptor for charger*1/PQLV209T or PQLV219Z 1 Rechargeable batteries*2 2 Handset cover*3/PNYNTGA430BR 1 Belt clip/PNKE1004Z1 1 *1 Both of the AC adaptors function well with the charger. *2 Please read the base unit’s operating instructions for replacement battery information. *3 The handset cover comes attached to the handset.
TGA939(e).fm Page 3 Friday, June 27, 2008 5:40 PM L The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) Battery installation and battery charge Important: L Use the supplied rechargeable batteries (Part No. HHR-55AAABU). L When installing the batteries: – Wipe the battery ends (S, T) with a dry cloth. – Avoid touching the battery ends (S, T) or the unit contacts. – Confirm correct polarities (S, T).
TGA939(e).fm Page 4 Friday, June 27, 2008 5:40 PM Attention: A nickel metal hydride battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY (1800-822-8837) for information on how to recycle this battery. Registering a handset to the base unit 1 Handset: Lift the handset and press {OFF}. 2 Base unit: Press and hold {LOCATOR} for about 5 seconds until the registration tone sounds. L If all registered handsets start ringing, press the same button to stop.
TGA939(e).fm Page 5 Friday, June 27, 2008 5:40 PM Wall mounting 1 Drive the screws (not supplied) into the wall. 2 Mount the charger (A), then slide it down (B) and to the right (C) until it is secure. 25.4 mm (1 inch) A B C Screws (120 V AC, 60 Hz) Belt clip You can hang the handset on your belt or pocket using the supplied belt clip. N To attach the belt clip N To remove the belt clip For assistance, please visit http://www.panasonic.
TGA939(e).fm Page 6 Friday, June 27, 2008 5:40 PM For your safety To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Power connection L Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire. L Regularly remove any dust, etc.
TGA939(e).fm Page 7 Friday, June 27, 2008 5:40 PM Battery L We recommend using the supplied batteries or additional/replacement batteries noted in the base unit’s operating instructions for replacement battery information. USE ONLY rechargeable Ni-MH batteries AAA (R03) size. L Do not mix old and new batteries. L Do not open or mutilate the batteries. Released electrolyte from the batteries is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
TGA939(e).fm Page 8 Friday, June 27, 2008 5:40 PM Notice for product disposal, transfer, or return L This product can store your private/confidential information. To protect your privacy/confidentiality, we recommend that you erase the information such as phonebook or caller list entries from the memory before you dispose of, transfer, or return the product. FCC and other information This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68.316.
TGA939(e).fm Page 9 Friday, June 27, 2008 5:40 PM CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TGA939(e).fm Page 10 Friday, June 27, 2008 5:40 PM Compliance with TIA-1083 standard: Compatible with Hearing Aid T-Coil Telephone handsets identified with this logo have reduced noise and interference when used with T-Coil equipped hearing aids and cochlear implants. T TIA-1083 Notice LThis product is designed for use in the United States of America. Sale or use of this product in other countries may violate local laws. LCet appareil est conçu pour être utilisé aux États-Unis d’Amérique.
TGA939(e).fm Page 11 Friday, June 27, 2008 5:40 PM If you need assistance with setup or operation 1 Visit our website: http://www.panasonic.com/help 2 Contact us via the web at: http://www.panasonic.com/contactinfo 3 Call us at: 1-800-211-PANA (1-800-211-7262) TTY users (hearing or speech impaired users) can call 1-877-8338855. When you ship the product L Carefully pack your unit, preferably in the original carton. L Attach a letter, detailing the symptom.
TGA939(sp).fm Page 1 Friday, June 27, 2008 4:06 PM Manual de instalación Auricular Inalámbrico Digital Adicional Modelo N° KX-TGA939 Gracias por adquirir un teléfono inalámbrico digital Panasonic. Esta unidad es un auricular adicional compatible con los siguientes teléfonos inalámbricos digitales Panasonic: KX-TG9391/KX-TG9392 Debe registrar este auricular con su unidad base antes de poder usarlo. Este manual de instalación sólo describe los pasos necesarios para registrar y comenzar a usar el auricular.
TGA939(sp).fm Page 2 Friday, June 27, 2008 4:06 PM Accesorios incluidos Accesorio/Número de pedido Cantidad Cargador/PNLC1001YT 1 Adaptador de corriente para el cargador*1/PQLV209T o PQLV219Z 1 *2 Baterías recargables 2 Tapa del auricular*3/PNYNTGA430BR 1 Gancho para el cinturón/PNKE1004Z1 1 *1 Los dos adaptadores para corriente funcionan bien con el cargador. *2 Lea las instrucciones de operación de la unidad base para obtener información acerca de las baterías de reemplazo.
Nota: L Use sólo el adaptador de corriente Panasonic PQLV209 o PQLV219 incluido. L El adaptador de corriente debe permanecer conectado todo el tiempo. (Es normal que el adaptador se caliente durante su uso.) Instalación y carga de la batería Importante: L Utilice las baterías recargables que se suministran (N° de serie HHR-55AAABU). L Al instalar las baterías: – Limpie los extremos de las baterías (S, T) con un paño seco. – Evite tocar los extremos de las baterías (S, T) o los contactos de la unidad.
Nota: (4)
TGA939(sp).fm Page 5 Friday, June 27, 2008 4:06 PM Montaje en la pared 1 Inserte los tornillos (no incluidos) en la pared. 2 Monte el cargador (A) y deslícelo hacia abajo (B) y a la derecha (C) hasta que quede bien asegurado. 25.4 mm (1 pulgada) A B C Tornillos (120 V CA, 60 Hz) Gancho para el cinturón Usted puede colgar el auricular en el cinturón o bolsillo usando el gancho para el cinturón incluido.