Operation Manual

Amber On R The base unit’s IP address may conflict with the IP
addr
esses of other devices on your local network. Contact
your administrator for further information.
Slow Flashing R The base unit is obtaining an IP address or is obtaining
conf
igurations. Please wait.
R The base unit is registering with your phone system. Please
wait
R If the STATUS indicator continues flashing, check the
following:
– Network settings may not be correct. Contact your
administrator.
– Many installation issues can be resolved by resetting all
the equipment. First, shut down your modem, router, hub,
base unit, and computer. Then turn the devices back on
one at a time in this order: modem, router, hub, base unit,
computer.
– If you cannot access Internet Web pages using your
computer, check to see if your phone system is having
connection issues in your area.
– For more troubleshooting help, contact your administrator.
Quick Flashing R Unplug the base unit’s AC adaptor to reset the unit, then
reco
nnect the AC adaptor. If the STATUS indicator is still
flashing rapidly, there may be a problem with the base unit
hardware. Contact your phone system dealer/service
provider.
Slow switching
(RedaGr
eenaAmber
aOff)
The base unit is in maintenance mode. Turn the base unit off
and then back on again.
Quick switching
(RedaGr
eenaAmber
aOff)
The base unit is restarting. Wait a moment.
Off — R The base unit power is off.
R The
Ethernet cable is not connected properly. Connect it.
R Your network devices (hub, router, etc.) are turned off.
Check the LEDs for the link status of the devices.
Note
R The i
ndicator flashing patterns are as follows:
– Slow Flashing: 60 times per minute
– Quick Flashing: 240 times per minute
Handset locator button
You c
an locate a misplaced handset/desk phone by paging it.
If you press the button again, or after 60 seconds have passed, the page to the handset/desk phone
will be stopped.
You can also register the handset/desk phone to the base unit by pressing and holding the button for
about 3 seconds.
For details, see “Handset/desk phone registration using the base unit”, Page 86.
20
Before Operating the Telephones