Operation Manual
KX-TPA60:
/ /[XFER/CLR]
KX-TP
A65:
/ /[TRANSFER/CLEAR]
Holding a Call
You c
an put a call on hold by holding the call at your extension.
Holding
To ho
ld the current call
1. KX-TPA60:
/ /[HOLD/MSG]
KX-TP
A65:
/ /[HOLD]
Note
R If
you select a LINE key other than the one for the current call, the call is put on hold or is disconnected
depending on the Automatic Call Hold settings. For details, contact your phone system dealer/service
provider.
To retrieve a call on hold
1. KX-TPA60:
/ /[HOLD/MSG]
KX-TPA65:
/ /[HOLD]
To re
trieve a call on hold at your line (when connected to the KX-TGP600 only)
1.
/[LINE]
2. Pre
ss the dial key corresponding to the slowly flashing green LINE indicator, or press [D] or [C] to
select a slowly flashing green LINE indicator. a
OK
Holding in a System Parking Zone (Call Park)
Y
o
u
c
an use this feature as a transferring feature.
When Call Park is permitted, the "Call Park" item is available in the Function Key list. However, the Call
Park feature number must be set beforehand. Also, depending on your phone system, you may need to
enter a parking zone number to retrieve a parked call. The feature depends on your phone system.
Contact your administrator for further information.
To set
1.
/[FUNC]/[FUNCTION] a 9 ("Ca
ll Park")
To retrieve (Call Park Retrieve)
[In standby mode]
1. Enter the Call Park Retrieve feature number.
2. KX-TPA60:
KX-TPA65: Off-hook
Note
R De
pending on the telephone system, the
PARK
soft key might blink to show that the line has a parked
call.
In this case, you can retrieve the call by pressing the blinking
PARK
soft key. However, to retrieve
57
During a Conversation