Operating Manual
• When the authentication password is
displayed as asterisks
(*), pressing [Y]
deletes the entire authentication password.
"H.460": Use [
][ ] to select "ON" or
"OFF" (default).
• This setting is available only when "OFF" is
selected for "Static NAT" (Page 119) and
"ON" is selected for "Gatekeeper".
5. Press [G].
• A
dialogue box to confirm the saving of settings
is displayed.
6. Use [
][ ] to select "Yes" and press [Enter].
• The administrator menu screen is displayed.
7. Press [Home].
• The Home screen is displayed.
Making Static NAT Settings
Note
• To change the static NAT settings, it is
necessary to configure system settings,
including the port number settings. For details,
contact your dealer.
• These settings can only be made in IP mode
(Page 115).
• This setting is available only when "IP
Address" is set to "Manual" in "Network
Settings" (Page 97).
1. Log in to the administrator menu
(Page 112).
• The administrator menu screen is displayed.
2. Press [
].
• The second page is displayed.
3. Use [ ][ ] to select "Static NAT Settings" and
press [Enter].
• The Static NAT settings screen is displayed.
4. Use [ ][ ]
to select the following items for input:
"Static NAT": Use [
][ ] to select "ON" or
"OFF" (default).
Note
• To select "ON", "H.460" must be set to
"OFF" on the H.323 settings screen
(Page 119).
• When "ON" is selected, the IP address of
the WAN side will be displayed for the unit
information
on the Home screen (Page 36).
"WAN IP Address": Enter the WAN IP address of
the router.
Note
• If the IP address contains 1 or 2 digit
numbers,
enter these numbers as they are.
Do not enter like [.001].
Example: The IP address is [192.168.0.1].
– Correct entry: [192.168.0.1]
– Wrong entry: [192.168.000.001]
• If "Obtain automatically" is displayed, the
WAN IP address cannot be set. For details,
contact your dealer.
"RTP and RTCP for Audio": Enter the initial port
number (5100–5194) for RTP and RTCP for Audio
(default: 5100).
"RTP and RTCP for Video": Enter the initial port
number (5200–5294) for RTP and RTCP for Video
(default: 5200).
"Camera Control": Enter the initial port number
(5300–5394) for controlling a video camera (default:
5300).
Document Version 2013-09 User Manual 119
Contacts and Settings