Operating Instructions

2.1 Connections
Important:
R The unit will not work during a power failure. We
recommend connecting a corded-type telephone
(without AC adaptor) to the same telephone line
or to the same telephone line jack, if you have
such a telephone jack in your house.
2.1.1 Base unit
A
Telephone line cord
R Connect to a single telephone line jack.
B Power cord
R Connect to a power outlet (220 V – 240 V,
50/60 Hz).
B
A
Caution:
R When you operate this product, the power outlet
should be near the product and easily accessible.
R Be sure to use the telephone line cord included
in this unit.
R Do not extend the telephone line cord.
Note:
R If any other device is connected to the same
telephone line, this unit may disturb the network
condition of the device.
R
If you use the unit with a computer and your internet
provider instructs you to install a filter (C), please
connect it as follows.
C
2.1.2 Charger unit (KX-FC278 only)
A
AC adaptor
R Connect to a power outlet (220 V – 240 V,
50/60 Hz).
B Hooks
R Fasten the AC adaptor cord to prevent it from
being disconnected.
C Screws (not included)
R The charger can be mounted on the wall, if
required.
25 mm
C
A
B
2 mm
*1
*1 Use screws longer than 20 mm.
Caution:
R USE ONLY WITH the supplied Panasonic AC
adaptor.
R The AC adaptor must remain connected at all
times. (It is normal for the adaptor to feel warm
during use.)
R The AC adaptor should be connected to a
vertically oriented or floor-mounted AC outlet. Do
not connect the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the adaptor may cause
it to become disconnected.
17
2. . Preparation
2. Preparation