Operating Instructions

7.1 Base unit programming
MMENUNMSETN
1. MMENUN
2. Press MBN and the 2-digit code (page 39 to
page 44).
3. Press the desired command to display the desired
setting.
R This step may be slightly different depending on
the feature.
4. MSETN
5. To exit programming, press MMENUN.
7.1.1 Basic features
Feature Selection
Setting the date and time
*1
MBNM0NM1N
Enter the date and time using the dial keypad. See page 19 for details.
Setting your logo
MBNM0NM2N
Enter your logo using the dial keypad. See page 20 for details.
Setting your fax number
MBNM0NM3N
Enter your fax number using the dial keypad. See page 20 for details.
Printing a sending report
MBNM0NM4N
M0N “OFF”: Sending reports will not be printed.
M1N “ON”: A sending report will be printed after every fax transmission.
M2N “ERROR” (default): A sending report will be printed only when a fax
transmission fails.
Changing the ring count in
FAX ONLY mode
MBNM0NM6N
M1N “1”, M2N “2” (default), M3N “3”, M4N “4”, M5N “5”, M6N “6”, M7N “7”, M8N
“8”, M9N “9”
Note:
R Set feature #77 to “FAX ONLY” (page 44) beforehand.
Changing the ring count in
TAM/FAX mode
*1
MBNM0NM6N
M0N “AUTO”, M2N “2” (default), M3N “3”, M4N “4”, M5N “5”, M6N “6”, M7N “7”
See page 32 for details.
Note:
R Set feature #77 to “TAM/FAX” (page 44) beforehand.
R You can also program this feature with the cordless handset (page 37).
Changing the maximum
recording time for incoming
messages
*1
MBNM1NM0N
M1N “1 MINUTE”
M2N “GREETING ONLY”: The unit plays the greeting message but does not
record any incoming messages.
M3N “3 MINUTES” (default)
Note:
R You can also program this feature with the cordless handset (page 37).
Setting the remote operation
ID
*1
MBNM1NM1N
1. MMENUN A MBNM1NM1N
2. To activate the remote operation feature, enter a 3-digit remote operation
ID.
R To deactivate the remote operation feature, press MGN.
3. MSETN A MMENUN
Note:
R You can also program this feature with the cordless handset (page 37).
39
7. . Programmable Features
7. Programmable Features