Operating Instructions

Feature Selection
Setting the auto
disconnection
MBNM4NM9N
To answer a call with an extension telephone in TEL/FAX mode (page 30), or
TAM/FAX mode (page 31) activate this feature and program the code.
M0N “OFF”
M1N “ON” (default)
1. MMENUN A MBNM4NM9N
2. Press M1N to select “ON”. A MSETN
3. Enter your code from 2 to 4 digits, using 0-9 and MGN.
R The default code is “H0”.
4. MSETN A MMENUN
Changing the greeting
message time for TAM/FAX
MBNM5NM4N
M1N “16s” (default): Maximum greeting message time is 16 seconds.
M2N “60s”: Maximum greeting message time is 60 seconds.
See page 35 for details.
Setting the scan contrast
MBNM5NM8N
To send or copy a document with faint or dark writing, set this feature before
transmission or copying.
M1N “NORMAL” (default): Used for normal writing.
M2N “LIGHT”: Used for dark writing.
M3N “DARKER”: Used for faint writing.
Copying phonebook data
from the base unit to the
cordless handset
MBNM5NM9N
M1N “1 ITEM” (default)
M2N “ALL ITEMS”
See page 49 for details.
Setting the ADSL mode
MBNM6NM2N
If you use a DSL/ADSL line, an echo may occur during a telephone
conversation. In this case, activate this feature. The volume of your voices will
be slightly decreased to reduce the echo.
M0N “OFF” (default)
M1N “ON”
Screening the incoming call
MBNM6NM7N
To hear an incoming call from the speaker when the answering machine is
recording the message.
M0N “OFF”
M1N “ON” (default)
Setting the Error Correction
Mode (ECM)
MBNM6NM8N
This feature is available when the transmitting/receiving fax machines are ECM
compatible.
M0N “OFF”: Deactivates this feature.
M1N “ON” (default): If there is an error during fax transmission/reception, the unit
will support the communication.
Note:
R You cannot change the setting when received documents are in memory.
Setting recall/flash time (for
the base unit and cordless
handset)
MBNM7NM2N
The recall/flash time depends on your telephone exchange or host PBX.
M1N “900msec.”, M2N “700msec.”, M3N “600msec.” (default), M4N
“400msec.”, M5N “300msec.”, M6N “250msec.”, M7N “200msec.”, M8N
“160msec.”, M9N “110msec.”, MGN “100msec.”, M0N “90msec.”, MBN
“80msec.”
Note:
R If the unit is connected via a PBX, this setting may need to be changed in
order for PBX functions (transferring a call, etc.) to work correctly. Consult
your PBX supplier for the correct setting.
Changing the receiving mode
in the manual answer setting
MBNM7NM3N
M1N “TEL” (default): Telephone mode (page 30)
M2N “TEL/FAX”: Telephone/Fax mode (page 30)
43
7. Programmable Features