Operating instructions

Features Summary
57
Code Feature & Display Settings How the unit operates
#39
Changing the display contrast
LCD CONTRAST
NORMAL
DARKER
“NORMAL”: For normal contrast
“DARKER”: Used when the display
contrast is too light.
#41
Changing the fax activation code
If you use an extension telephone
and wish to use it to receive a fax,
activate this feature, and enter the
code (p. 42).
●
This code is also used to receive
a voice message and a fax in the
same call (p. 41).
FAX ACTIVATION
ON /
CODE=
??
9
OFF
1.
Follow steps 1–3 on page 56.
2. Rotate g to select “ON”.
3. Press w .
4. Enter your code from 2 to 4 digits,
using 0–9 and : .
5. Press w .
6. Press p .
●
Do not enter “0000”.
#44
Setting the memory reception
alert
To alert you with a beeping sound
when a document which has been
received is stored into memory due
to some existing problem.
RECEIVE ALERT
ON
OFF
If you are alerted by a slow
beeping sound, clear the printing
problem and make sure the unit is
supplied with enough paper to print
the stored document. The beeps
will stop.
#68
Setting the Error Correction
Mode (ECM)
To send a fax even if there is static
interference on the telephone line.
ECM SELECTION
ON
OFF
This feature is available when the
transmitting/receiving stations are
ECM compatible.
#80
Resetting advanced features to
their default settings
SET DEFAULT
YES
NO
1. Follow steps 1–3 on page 56.
2. Rotate g to select “YES”.
3. Press w.
4. Press w again.
5. Press p.
#79
Saving on toner consumption
TONER SAVE
ON
OFF
“ON”: The toner cartridge will last
longer.
●
This feature may lower the print quality.
You can confirm the status of the
other party’s machine.
●
If the ring back tone continues, the
other party’s machine may not be a
facsimile or may have run out of
paper. Check with the other party.
●
The connecting tone volume
cannot be adjusted.
#76
Setting the connecting tone
If you often have trouble when
sending a fax, this feature allows
you to hear connecting tones: fax
tone, ring back tone and busy tone.
CONNECTING TONE
ON
OFF
(The default setting is in bold type.)