Operating Instructions

Green and yellow Hub is starting up
Red Alarm system is armed
Alarm system was triggered
Yellow Initial setup required
Initial setup in progress, mobile device connected
Initial setup is starting
*1 You can configure the hub so that its LED indicator does not light in most states. See “General
settings”, Page 110.
Camera LED indicator
Off
No power, or LED indicator is turned off
*1
Green Normal operation
Registration mode
Red
Motion detected
*2
Live images are being viewed or recorded
Camera is out of range of the hub, or device malfunction
Orange Camera is not registered to a hub
*1 You can configure the camera so that its LED indicator does not light in most states. See “Device
profiles (device settings)”, Page 103.
*2 The LED indicator does not light when the indoor camera’s temperature sensor is triggered.
Motion sensor LED indicator
The LED indicator on the motion sensor does not light during normal operation. You can press
and
check the LED indicator to confirm the sensor’s status.
Off No battery power
Green No motion detected
Registration mode (you pressed and held )
Red Motion detected
Sensor is out of range of the hub, or is not registered to a hub
Note:
R After pressing and confirming the sensor’s status, press again to turn off the LED
indicator and conserve battery power.
47
Using the app