Operating Instructions

– Motion sensors: Enabled

– Water leak sensors: Enabled and cannot be disabled

– Glass break sensors: Enabled

– Garage door sensors: Enabled

– Indoor camera motion detection features: Disabled

– Outdoor camera motion detection features: Enabled

Disarm

Use this mode to turn off the alarm system.

R Water leak sensors can always trigger the alarm system, even when this mode is selected.

Confirming the current arm mode

The icons displayed near the top of the home screen indicate the current arm mode.

See “Arm mode icons”, Page 38 for details.

Changing the current arm mode

Tap the icon of the desired arm mode at the top of the [Home Network] app home screen.

Alarm system settings

You can customize settings for [Arm: At Home] mode and [Arm: Away] mode to suit your needs.

1 From the [Home Network] app home screen, tap [Settings].

2 Tap [Arm Settings].

3 Select which type of settings you want to change.

– [Arm Settings (At Home)]: The settings you change will be applied when the arm mode is set to

[Arm: At Home].

– [Arm Settings (Away)]: The settings you change will be applied when the arm mode is set to

[Arm: Away].

– [Alert by Phone Call]: See “Alert by phone call”, Page 54.

– [Change Arm PIN]: See “Alarm system PIN”, Page 56.

4 Select the desired setting.

5 Change the settings as desired.

R Each setting is explained in this section.

6 Follow the on-screen instructions.

Enabling and disabling individual sensors

While configuring the settings for an arm mode, tap the name of the desired sensor and then select the

desired operating mode.

– [Enable]: This setting enables the selected sensor during the corresponding arm mode.

– [Enable (Entry Delay)]: This setting is the same as when [Enable] is selected, but an entry delay is

also applied. For more information, see “Entry delay time and alert volume (available for [Arm: Away]

mode and [Arm: At Home] mode)”, Page 54.

– [Disable]: This setting disables the selected sensor during the corresponding arm mode.

Exit delay time and alert volume (available for [Arm: Away] mode only)

The exit delay can give you time to leave the house before the alarm system is armed. This setting

determines the amount of time.

When you change the arm mode to [Arm: Away], the exit delay begins counting down. During this time,

the alarm system cannot be triggered.

Using the app