Operating Instructions
Feature/Code Selection
Setting the ADSL mode
MBNM1NM2NM4N
(KX-MB1520/KX-MB1530
only)
When you use a DSL/ADSL line, this feature improves the reliability by reducing
the transmission speed.
M0N “OFF” (default)
M1N “ON”
Note:
R Calling charges may be higher than usual.
Changing the LCD display
contrast
MBNM1NM4NM5N
M1N “NORMAL” (default)
M2N “DARKER”
Selecting the scale
MBNM1NM4NM7N
M1N “MILLIMETRES” (default)
M2N “INCHES”
Note:
R The selected scale will be used when measurements are shown on the
unit’s display.
Changing the password for
feature programming via
remote operation
MBNM1NM5NM5N
1. MMenuN A MBNM1NM5NM5N A MSetN
2. Enter the current password. A MSetN
R The default password is “1234”.
3. Enter a new 4-digit password using 0-9. A MSetN
4. Enter the new password again. A MSetN A MMenuN
Note:
R It is recommended that you change this password from the default
password.
Setting the toner
maintenance time
MBNM1NM5NM8N
(KX-MB1520/KX-MB1530
only)
The unit will automatically activate for maintenance, once every 24 hours.
Because this is to prevent the toner from solidifying, the noise that the unit
makes during maintenance cannot be stopped. However, if the unit’s noise
bothers you, you can change the start time.
1. MMenuN A MBNM1NM5NM8N A MSetN
2. Enter the maintenance start time.
R The default time is “12:00”.
R If you selected 12-hour time entry (page 20), press MHN repeatedly to
select AM or PM.
R If you selected 24-hour time entry (page 20), the time is set using
24-hour time entry.
3. MSetN A MMenuN
Resetting all features (and
deleting all data in memory)
MBNM1NM5NM9N
Before you dispose of, transfer or return the product, activate this feature to
reset all programmable features and to delete all data stored in memory.
KX-MB1520/KX-MB1530 only: Phonebook (or caller information) and fax
transmission data (journal report and faxes received in memory) will be deleted.
M0N “NO” (default)
M1N “YES”
R Disconnect the telephone line cord (KX-MB1520/KX-MB1530 only) and
USB cable before activating this feature.
To reset all features:
1. MMenuN A MBNM1NM5NM9N
2. Press M1N to select “YES”. A MSetN
3. Press M1N to select “YES”. A MSetN
Setting the ringer pattern
MBNM1NM6NM1N
(KX-MB1520/KX-MB1530
only)
M1N “A” (default)
M2N “B”
M3N “C”
52
8. Programmable Features