Operating Instructions

2.3 Setting the original
2.3.1 Using the scanner glass
A
B
1 Open the document cover (A).
2 Place the document FACE DOWN on the scanner
glass (B), aligning the top left of the document with
the corner where the
mark is positioned.
3 Close the document cover.
Note:
R Confirm that there are no documents in the automatic
document feeder (KX-MB1530 only).
R Place the original onto the scanner glass gently. To
avoid malfunction, do not press down too firmly.
R If the original is a book thicker than 15 mm, do not
close the document cover.
R Confirm that any ink, paste or correction fluid has
dried completely.
R Effective scanning area is shown by the shaded area:
Effective scanning area
208 mm
289 mm
4 mm
4 mm
4 mm
4 mm
2.3.2 Using the automatic document feeder
(KX-MB1530 only)
1 Open the document sub tray (A) by pressing its
centre part (B).
B
A
2 Insert the document (up to 15 pages) FACE DOWN
into the feeder until a single beep is heard.
C
3 Adjust the width of the document guides (C) to fit the
actual size of the document.
Note:
R Do not place the unit in an area where the document
sub tray may be easily bumped into.
R The order of multiple page documents will be
reversed after being fed through the automatic
19
2. Preparation