Operating Instructions

For your safety
Laser radiation
CLASS 1 LASER PRODUCT
R The printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Laser diode properties
Laser output : Max. 10 mW
Wavelength : 760 nm - 800 nm
Emission duration : Continuous
LED light
CLASS 1 LED PRODUCT
R When using the unit, do not look directly at the
CIS’s LED light. Direct eye exposure can cause
eye damage.
CIS’s LED light properties
LED radiation output : Max. 1 mW
Wavelength :
Red 630 nm typical
Green 520 nm typical
Blue 465 nm typical
Emission duration : Continuous
Fuser unit
R
During or immediately after printing, the fuser unit
(A) gets hot. This is normal. Do not touch the fuser
unit.
Note:
R The area near the rear cover (B) may also get warm.
This is normal.
AB
For best performance
Toner cartridge
R When replacing the toner cartridge, do not allow dust,
water, or liquids to come in contact with it. This may
affect print quality.
R For optimal performance, genuine Panasonic toner
cartridge is recommended. We cannot be
responsible for problems that may be caused by a
non-Panasonic toner cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
R Do not leave the toner cartridge out of the protective
bag for a long time. It will affect the printing quality.
R Read the instructions on page 11 before you begin
installation of the toner cartridge. After you have read
them, open the toner cartridge protective bag. The
toner cartridge contains a photosensitive drum.
Exposing it to light may damage the drum.
– Do not expose the toner cartridge to light for more
than 5 minutes.
– Do not touch or scratch the drum surface (A).
A
– Do not place the toner cartridge near dust or dirt,
or in a high humidity area.
– Do not expose the toner cartridge to direct
sunlight.
R To extend the life of the toner cartridge, the power
should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.
Location
R To avoid malfunction, do not position the unit near
appliances such as TVs or speakers which generate
an intense magnetic field.
Static electricity
R To prevent static electricity damage to the interface
connectors or other electrical components inside the
unit, touch a grounded metal surface before touching
the components.
Environment
R Keep the unit away from electrical noise generating
devices, such as fluorescent lamps and motors.
R The unit should be kept free from dust, high
temperature and vibration.
4
Important Information