Operating Instructions
Table Of Contents
- Available features list
- Important Information
- Table of Contents
- Introduction and Installation
- Preparation
- Printer
- Scanner
- Copier
- Fax (KX-MB1520/KX-MB1530 only)
- Sending Faxes
- Receiving Faxes
- 6.5 Selecting the way to use your unit
- 6.6 Receiving a fax automatically : Auto answer ON
- 6.7 Receiving a fax manually : Auto answer OFF
- 6.8 Using the unit with an answering machine
- 6.9 Receive polling (retrieving a fax placed on another fax machine)
- 6.10 Junk fax prohibitor (preventing fax reception from undesired callers)
- 6.11 Receiving a fax on your computer
- Caller ID (KX-MB1520/KX-MB1530 only)
- Programmable Features
- Useful Information
- Help
- Paper Jams
- Cleaning
- General Information
- Index
Problem Cause & Solution
When using the unit as a
printer, the printing result is
distorted.
R When your unit is connected to the computer by USB, if you cancel printing
using your computer, then immediately re-start printing, the printing result
may be distorted. To avoid this, you must wait for 60 seconds before
re-printing.
10.3.3 Scanner
Problem Cause & Solution
I cannot scan. R When scanning at a high resolution, a large amount of available memory is
required. If your computer warns that there is insufficient memory, close
other applications and try again.
R Select a lower resolution and try again.
R Reduce the scanning area and try again.
1. To preview the scanned image, click [Preview].
2. You can drag the frame to specify the scanning area.
3. Click [Scan] to start scanning.
R The unit is in use. Try again later.
R There is not enough space on the hard disk. Delete unnecessary files and
try again.
R Check the connection between the computer and the unit (page 12, 24).
R Restart the computer, and try again.
R You attempted to scan a document longer than the paper size which you
set. Change the setting or divide the document into the appropriate paper
size, and try again.
The document is not fed into
the unit when using the unit
as a scanner (KX-MB1530
only).
R Remove the document in the automatic document feeder and re-insert it
(page 19).
Even after clicking [Cancel],
scanning continues.
R Please wait. It may take a while for the cancel request to be accepted.
10.3.4 Copier
Problem Cause & Solution
The unit will not make a copy. R You cannot make a copy during programming. Make the copy after
programming.
R The document was not set properly (page 19).
R Recording paper is not loaded or the unit has run out of paper. Load paper
(page 14).
Letters on the copied
documents are not clear.
R The original document is too dark or too light. Change the contrast
(page 32) and try again.
The copied documents are
too dark and cannot be read.
R You used a coloured paper as a document. Change the contrast (page 32)
and make a lighter copy of the document, using “TEXT” resolution
(page 32).
77
10. Help