Operating Instructions

Feature Code Description
Default
key
Recall/Flash time #121 The recall/flash time depends on your telephone exchange or host
PBX.
Note:
R If the unit is connected via a PBX, PBX functions (transferring a
call, etc.) might not work correctly. Consult your PBX supplier for
the correct setting.
–
ADSL mode #124 When you use a DSL/ADSL line, this feature improves the reliability
by reducing the transmission speed.
Note:
R Calling charges may be higher than usual.
M0N
LCD display
contrast
#145 To change the LCD display contrast.
M3N
Scale selection #147 The selected scale will be used when measurements are shown on
the unit’s display.
–
Display interval #148 To set display interval for messages showed alternately. M1N
Administrator
code
#151 To change the administrator code for mode restriction settings. When
entering the new code, using 0-9.
R The default administrator code is “0000”.
Note:
R It is recommended that you change this administrator code from
the default administrator code.
–
Mode restriction #154 To activate the mode restriction. See page 96 for details. M0N
Change password #155 To change the password for feature programming via remote
operation. When entering the new code, using 0-9.
R The default password is “1234”.
Note:
R It is recommended that you change this password from the default
password.
R This password is also used for feature programming via a web
browser (LAN supported models only). (y)
–
Maintenance time #158 The unit will automatically activate for self-maintenance. Enter the
maintenance start time by using the dial keypad.
R The default time is “12:00”.
Note:
R Do not activate the unit during self-maintenance.
–
Set all features to
default
#159 Before you dispose of, transfer or return the product, activate this
feature to reset all programmable features and to delete all data
stored in memory.
R The following items will be deleted.
– Address book
– Caller information (y)
– Fax transmission data (journal report and fax received in
memory) (y)
R Disconnect the following cord/cable before activating this feature.
– Telephone line cord (fax supported models only) (y)
– USB cable
– LAN cable (y)
–
Ringer pattern #161 To set the ringer pattern. M1N
39
3. Basic Operations