Operating Instructions

Feature Code Description
Default
key
ECM selection #413 To set the Error Correction Mode (ECM). This feature is available
when the sending / receiving fax machines are ECM compatible.
When this feature is activated, fax transmission / reception will be
carried out so that the errors do not occur.
M1N
Connecting tone #416 If you often have trouble when sending faxes, activating this feature
allows you to hear connecting tones: fax tone, ring back tone and busy
tone. You can use these tones to confirm the status of the other
party’s machine.
Note:
R If the ring back tone continues, the other party’s machine may not
be a fax machine or may have run out of paper. Check with the
other party.
R The connecting tone cannot be adjusted individually.
M1N
Maximum fax
speed
#418 To set the maximum fax speed (14.4 kbps/33.6 kbps). The fax speed
may be lower than the selected speed depending on your line.
M2N
Quick scan mode #419 To enable quick scan mode. When this feature is activated, the unit
will scan the document and store it into memory first, then the unit will
start sending the documents.
M0N
Confirming the
destination
#420 To confirm the destination before sending a fax. When it is activated,
you can send a fax after confirming the destination. When the
displayed destination is correct, press Mx/STARTN to send the fax.
M0N
Dial keypad entry
restriction
#421 If you want to restrict dialling fax numbers manually using the dial
keypad (to avoid misdialling, for example), activate this feature.
Note:
R When this feature is activated,
– you cannot make redial calls to fax numbers entered using the
dial keypad.
– the fax number re-entry setting (feature #422) will be
deactivated.
M0N
Fax number
re-entry
#422 When this feature is activated, if you dial a fax number manually using
the dial keypad, you have to re-enter the number and press Mx/
STARTN. When the 2nd entry number matches the 1st entry number,
you can send the fax.
M0N
Dial tone detection #423 When this feature is activated, a dial tone of sending faxes is detected
to check if the line is connected before starting transmission. If a dial
tone is not detected, the unit enters redial standby.
M1N
Confirming the
next document
#424 When this feature is activated, after the document is scanned using
the automatic document feeder during fax memory transmission, the
message shows to confirm the next document. Insert the next
document and press MOK/SETN. A Mx/STARTN
M0N
Activating the
Distinctive Ring
feature
#430 To activate the Distinctive Ring feature. See page 100 for details.
M0N
Setting the ring
pattern for fax
(Distinctive Ring
feature)
#431 To set the ring pattern for fax (Distinctive Ring feature). See
page 101 for details.
– “A”: Standard ring (one long ring)
– “B”: Double ring (two short rings)
– “C”: Triple ring (short-long-short rings)
– “D”: Other triple ring (short-short-long rings)
– “B-D”: The fax will respond to all calls with ring tone patterns
“B”, “C”, and “D”.
M5N
87
8. Fax