Operating Instructions

MFEN: “ERASE ALL” A MOK/SETN A MOK/SETN A Mw/STOPN
4. MCDN: Display the desired item. A Mt/MENUN A MBN
R To cancel erasing, press Mw/STOPN.
5. MOK/SETN A Mt/MENUN
10.2.2 Counter view and print for departments
Viewing the count number of copies/prints for departments
1. Mt/MENUN A MBNM4NM7NM9N A MOK/SETN
2. Enter the administrator code (feature #151). A MOK/SETN
3. MCDFEN: Select the desired item. A Mt/MENUN
Printing a report of the count number of copies/prints for departments
1. Mt/MENUN (repeatedly): “PRINT REPORT”
2. MFEN: “DEPT.PRINT COUNT” A MOK/SETN
3. Enter the administrator code (feature #151). A MOK/SETN
4. Mt/MENUN
Resetting the counters for departments
1. Mt/MENUN (repeatedly): “DEPARTMENT SETUP” A MEN
2. Enter the administrator code (feature #151). A MOK/SETN
3. MFEN: “RESET COUNTER” A MOK/SETN
4. MOK/SETN A Mw/STOPN
R To cancel resetting, press Mw/STOPN.
Note:
R The count numbers of copies/prints will be reset only when the mode restriction (feature #154) is activated.
10.3 QUICK-JOB feature
You can pre-program frequently used scan/copy types (up to 3 for each). The following setting items can be
pre-programmed:
Scan Copy
Job name Job name
Scanning mode Page layout
PC selection
*1
Number
Scan type Original size
Scan size Input tray
Resolution Zoom rate
File format Resolution
Brightness Duplex
Contrast Edge
– Margin
*1 LAN supported models only (y)
Programming the QUICK-JOB items
1. Set the unit to a desired mode (scan or copy).
2. M[/QUICK-JOBN
3. MCDN: Select the desired setting.
4. MFEN: Select the desired item.
97
10. Other Useful Features