Operating Instructions

Other programming
Changing the handset name
E
ach handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 MMenuN (right soft key) #104
2 Enter the desired name (max. 10
characters).
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times a M
N
Call restriction
Y
ou can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1 MMenuN (right soft key) #256
2 Enter the base unit PIN (default: “0000”).
R If you forget your PIN, see page 52.
3 Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R “
” is displayed next to the selected
h
andset numbers.
R To cancel a selected handset, press
the same dial key again. “
”
d
isappears.
4 MOKN
5 Select a memory location by pressing 1
to 6. a MOKN
6 E
nter the phone number or area code to
be restricted (8 digits max.). a MOKN a
M
N
Changing the base unit PIN
I
mportant:
R If you change the PIN (Personal
Identification Number), please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, see
page 52.
1 MMenuN (right soft key) #132
2 Enter the current 4-digit base unit PIN
(default: “0000”).
3 Enter the new 4-digit base unit PIN. a
MOKN
4 MbN: “Yes” a MOKN a M
N
Calendar/Schedule
Y
ou can program 20 schedule alarms for each
handset using the calendar. A schedule alarm
sounds at the set time for 1 minute. A text
memo can also be displayed for the schedule
alarm.
Important:
R Make sure the unit’s date and time setting
is correct (page 13).
Adding a new entry
1 MMenuN (right soft key) a a MO
KN
2 MbN: Select the desired date. a MOKN
3 MMenuN a MbN: “New Entry” a MOKN
4 Edit the date if necessary. a MOKN
5 Set the desired time. a MOKN
6 Enter a text memo (30 characters max.;
page 48). a MOKN
7 MbN: Select the desired alarm tone. a
MOKN 2 times
R You can select “Off” if you prefer not
to hear an alarm tone.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
31
Programming
PNQX6032YA_0529_ver110.pdf 31 2013/05/29 12:39:48