Operating Instructions

Problem Cause/solution
The handset beeps. R N
ew messages have been recorded. Listen to the new
messages (page 41).
The handset display
b
egins operating
automatically.
R Demonstration mode is activated. Please connect the
telephone line cord to the telephone line jack (page 10).
Menu list
Problem Cause/solution
The display is in a
l
anguage I cannot read.
R Change the display language (page 13).
I cannot activate the eco
m
ode.
R You cannot set eco mode when you set the DECT repeater
mode “On”. If required, set the DECT repeater mode to “Off”
(page 33).
I cannot display the
w
allpaper.
R Wallpaper is displayed in the standby mode only when you
select “Digital(Small)” or “Off” for the clock setting.
Change the clock setting (page 24).
I cannot register a handset
t
o a base unit.
R The maximum number of base units (4) is already registered
to the handset. Cancel unused base unit registrations from the
handset (page 33).
R The maximum number of handsets (6) is already registered to
the base unit. Cancel unused handset registrations from the
base unit (page 33).
R You entered the wrong PIN. If you forget your PIN, see “I
cannot remember the PIN.” (page 52).
I cannot remember the
P
IN.
R Change the PIN using the following method.
1 MMenuN (right soft key) #132
2 *7000
3 Enter the new 4-digit base unit PIN. a MOKN
4 MbN: “Yes” a MOKN a M
N
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R B
attery charge is low. Fully charge the batteries (page 10).
I fully charged the
b
atteries, but
–
still flashes or
–
the operating time
seems to be shorter.
R C
lean the battery ends (
, ) and the charge contacts with
a
dry cloth and charge again.
R It is time to replace the batteries (page 10).
52
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Useful Information
PNQX6032YA_0529_ver110.pdf 52 2013/05/29 12:39:49