Operating Instructions

16
Useful Information
Useful Infor mation
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Problem Cause & solution
w is flashing. L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
L The handset registration is cancelled. Register the
handset to the base unit using the following
method.
1 {j/OK}
2 “SETTING HS” i {>}
3 “REGISTRATION” i {>}
4 “REGISTER HS” i {>}
5 Press and hold {x} on the base unit for about
5 seconds.
L If all registered handsets start ringing, press
{x} to stop, then start again from step 1.
L The rest of the procedure must be completed
within 1 minute.
6 Press {e} or {v} to select a base unit number.
i {>}
7 Wait until “BS PIN” is displayed. i Enter
base unit PIN (default: “0000”). i {>}
L If you forget your PIN, see page 18.
L A confirmation tone will sound, and w will
stop flashing.
L If w is still flashing, start again from step 1.
TG1100_1102FX(e-e).book Page 16 Monday, June 9, 2008 2:09 PM