Operating Instructions

17
Useful Information
I cannot make or receive calls. L The AC adaptor or telephone line cord is not
connected. Check the connections.
L The call bar feature is turned on. Turn it off (page
11).
L You dialled a call restricted number (page 13).
L The key lock feature is turned on. Turn it off (page
9).
L The dialling mode setting is incorrect. Set to
“Tone” or “Pulse” as needed (page 8).
The unit does not ring. L The ringer volume is turned off. Adjust the ringer
volume (page 11).
The handset display is blank. L The handset is not turned on. Turn the power on
(page 6).
The handset will not turn on. L Make sure that the batteries are installed correctly
(page 6).
L Fully charge the batteries (page 6).
A busy tone is heard when {C}
is pressed.
L The handset is too far from the base unit. Move
closer and try again.
Static, sound cuts in/out, fades.
Interference from other electrical
units.
L Place the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter
(contact your DSL service provider) to the
telephone line between the base unit and the
telephone line jack.
Noise is heard during a call. L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
Pressing {R} does not display/
dial the last number dialled.
L The redialled number was more than 24 digits
long. Redial the number manually.
I fully charged the batteries, but
074 still flashes.
L Clean the charge contacts and charge again (page
6).
L It is time to replace the batteries (page 6).
I fully charged the batteries, but
the operating time seems to be
shorter.
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth, and charge again.
Problem Cause & solution
TG1100_1102FX(e-e).book Page 17 Monday, June 9, 2008 2:09 PM