Operating Instructions

Useful Information
21
Liquid damage
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up
the drying process.
Registering the handset to the base unit
1 {j/OK}
2 {v}/{e}: “SETTING HS” i {>}
3 {v}/{e}: “REGISTRATION” i {>}
4 {v}/{e}: “REGISTER HS” i {>}
5 Press and hold {x} on the base unit for about 5 seconds.
L If all registered handsets start ringing, press {x} to stop, then start
again from step 1.
L The rest of the procedure must be completed within 4 minutes.
6 {v}/{e}: Select a base unit number. i {>}
7 Wait until “BS PIN” is displayed. i Enter the base unit PIN (default:
“0000”). i {>}
L If you forget your PIN, see page 21.
L When the handset has been registered successfully, w stops
flashing.
L If w is still flashing, start again from step 1.
Changing the handset PIN
1 {j/OK}
2 {v}/{e}: “SETTING HS” i {>}
3 {v}/{e}: “OTHER OPT” i {>}
4 {v}/{e}: “HSPIN CHANGE” i {>}
5 {*}{7}{0}{0}{0}
6 Enter the new 4-digit handset PIN.
7 Enter the new 4-digit handset PIN again.
8 {ih}
Changing the base unit PIN
1 {j/OK}
2 {v}/{e}: “SETTING BS” i {>}
3 {5}
4 {*}{7}{0}{0}{0}
5 Enter the new 4-digit base unit PIN.
6 Enter the new 4-digit base unit PIN again.
7 {ih}
Problem Cause/solution
Liquid or other form of
moisture has entered the
handset/base unit.
L Disconnect the AC adaptor and
telephone line cord from the base unit.
Remove the batteries from the handset
and leave to dry for at least 3 days.
After the handset/base unit are
completely dry, reconnect the AC
adaptor and telephone line cord. Insert
the batteries and charge fully before
use. If the unit does not work properly,
contact your nearest Panasonic service
centre.
TG1311_1312_1313EG(e).book Page 21 Tuesday, October 21, 2008 5:04 PM