Operating Instructions

Preparation
7
Battery charge
Place the handset on the base unit or charger for about 7 hours before
initial use.
Battery level
Panasonic Ni-MH battery performance (supplied batteries)
Note:
L It is normal for batteries not to reach full capacity at the initial charge.
Maximum battery performance is reached after a few complete cycles of
charge/discharge (use).
L Actual battery performance depends on a combination of how often the
handset is in use and how often it is not in use (standby).
L Even after the handset is fully charged, the handset can be left on the
base unit or charger without any ill effect on the batteries.
L The battery level may not be displayed correctly after you replace the
batteries. In this case, place the handset on the base unit or charger and
let it charge for at least 7 hours.
Controls
Handset
Battery icon Battery level
5
High
L When flashing: Fully charged.
6 Medium
7
Low
L When flashing: Needs charging.
Operation Operating time
In continuous use 17 hours max.
Not in use (standby) 150 hours max.
A Receiver
B Display
C {k} (Phonebook)
D {C} (Talk)
E Navigator
({e}/{v}/{>}/{<})
? (Volume: {e}/{v})
F {R} (Redial/Pause)
G {R} (Recall/Flash)
H Microphone
I {j/OK} (Menu/OK)
J {ih} (Off/Power)
K {C} (Clear)
L {INT}
KX-TG1311:
To stop paging
KX-TG1312/KX-TG1313:
To stop paging/Intercom
M Charge contacts
N Ringer
N
A
B
C
K
L
M
J
D
E
F
G
H
I
TG1311_1312_1313EG(e).book Page 7 Tuesday, October 21, 2008 5:04 PM