Operating Instructions

Getting Started
14
4 {V}/{^}: “Select Language” i
{j/OK}
5 {V}/{^}: Select your desired
language. i {j/OK} i {ic}
Note:
L If you select a language you cannot
read: {ic} i {j /OK} i
{^} 3 times i {j/OK} i
{V} 2 times i {j/OK} 2 times i
{V}/{^}: Select your desired
language. i {j/OK} i {ic }
Dialling mode
If you cannot make calls, change this
setting according to your telephone line
service. The default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 {j/OK}
2 {V}/{^}: “Base Unit Setup” i
{j/OK}
3 {V}/{^}: “Dial Mode” i
{j/OK}
4 {V}/{^}: Select the desired setting.
i {j/OK} i {ic}
Date and time
1
{j/OK}
2 {V}/{^}: “Handset Setup” i
{j/OK}
3 {V}/{^}: “Set Date & Time” i
{j/OK}
4 Enter the current date, month, and
year.
Example: 15 July, 2010
{1}{5} {0}{7} {1}{0}
5 Enter the current hour and minute.
Example: 9:30
{0}{9} {3}{0}
L You can select 24-hour or 12-hour
clock format (“AM” or “PM”) by
pressing {*}.
6 {j/OK} i {ic}
Note:
L To correct a digit, press {<} or {>} to
move the cursor to the digit, then
make the correction.
L The date and time may be incorrect
after a power failure. In this case, set
the date and time again.
One touch eco mode
When the handset is on the base unit,
the base unit transmission power is
reduced up to 99.9% if only one handset
is registered.
Even when the handset is not on the
base unit or several handsets are
registered, the base unit transmission
power in standby mode can be reduced
up to 90% by activating one touch eco
mode.
You can turn on/off one touch eco mode
by just pressing {ECO/R}. The default
setting is “Normal”.
– When the one touch eco mode is on:
“Low” is temporarily displayed and
“ECO” is shown on the handset
display.
– When the one touch eco mode is off:
“Normal” is temporarily displayed
and “ECO” goes off from the handset
display.
Note:
L When there is another cordless phone
nearby and it is in use, the base unit
transmission power may not be
reduced.
L Activating one touch eco mode
reduces the range of the base unit in
standby mode.
L If you set the repeater mode to “On”
(page 22), one touch eco mode is
cancelled.
TG2511_21FX(e).book Page 14 Tuesday, February 2, 2010 3:08 PM